Register Community Calendar Today's Posts Search

Go Back   GZ 250 Forums > GZ250-Specific > General Maintenance

Reply
 
Thread Tools Display Modes
Old 01-28-2010, 01:01 AM   #11
Water Warrior 2
Senior Member
 
Join Date: Dec 2006
Location: Squamish B.C Canada
Posts: 11,409
Re: Starting the Bike effectively

You might want to invest in a Battery Tender. They are smart little trickle chargers that will maintain a battery without overcharging it.



Login or Register to Remove Ads
Water Warrior 2 is offline  
Reply With Quote
Old 01-28-2010, 03:10 AM   #12
alanmcorcoran
Senior Member
 
Join Date: Jul 2008
Location: Anaheim, CA
Posts: 2,926
Re: Starting the Bike effectively

I put the choke on all the way. I don't give it any gas prior to pushing the starter, but I do give the throttle about an eighth of a turn once I hit the button. I hold the button in until it catches - which is sometimes a few seconds. Once it catches, I give it a second or so, rev it once or twice and just let it run for a little. If it's been recently ridden, that's it. If it's been sitting for a while (a week or more) I let it warm up a bit before I take off. I listen to the revs and as they creep up, I back off the choke. Typically, after a few minutes I can take it off completely.

I don't ride mine everyday anymore ever since I got the bigger bike and unless I devote a week to it (or a 150 mile ride to nowhere) it's just not going to run like it once did. But even with frequent layoffs of a week or two (or three) it still starts up relatively easily and runs decent. It's a little sloppy/choppy in second gear until I get a few miles in, but pretty good in third, fourth and fifth. Mine is an '08 and I completely ran the battery down on it twice. (I have a charger.) I also have a tender but I haven't ever hooked it up.

Keep in mind, I am in Southern California. It hardly ever gets below 40 here, so naturally mine will start easier. The cold also has a negative effect on batteries, so it's kind of a double whammy. mrlmd has posted on here about jumping from a car battery. I'd try that if I were you and see if it works better. Then you know your battery is the issue. If not, it might be the carb needs cleaning.
__________________
[hr:5yt6ldkq][/hr:5yt6ldkq]
http://alanmarkcorcoran.com Motorcycles, Music, Musings and More…
alanmcorcoran is offline  
Reply With Quote
Old 01-28-2010, 08:55 AM   #13
burkbuilds
Senior Member
 
burkbuilds's Avatar
 
Join Date: Mar 2009
Location: Shannon, Georgia
Posts: 1,268
Re: Starting the Bike effectively

Pretty much all of the above, also I was wondering if you've ever had the valves adjusted? I noticed how much better my GZ cranked right up after a valve adjustment and I did mine about every 5,000 miles, and I noticed that you had over 7,000 on your GZ.



Login or Register to Remove Ads
burkbuilds is offline  
Reply With Quote
Old 01-28-2010, 09:46 AM   #14
bonehead
Senior Member
 
Join Date: May 2009
Location: elgin,tx
Posts: 907
Re: Starting the Bike effectively

Quote:
Originally Posted by burkbuilds
Pretty much all of the above, also I was wondering if you've ever had the valves adjusted? I noticed how much better my GZ cranked right up after a valve adjustment and I did mine about every 5,000 miles, and I noticed that you had over 7,000 on your GZ.
:plus1:
__________________
Standing with the PGR until they stand for me.
bonehead is offline  
Reply With Quote
Old 02-21-2010, 12:52 PM   #15
johnd
Junior Member
 
Join Date: Jun 2009
Location: charlotte, nc
Posts: 18
Re: Starting the Bike effectively

Hi to all and I especially reading from Easy, Sarris, WW and Bb. Yesterday I rolled out my bike and it would not spin fast enough to crank. I jumped it off with lawnmower cables. My MotoFino 49cc would not start either. It has been very cold here for a long time considering this area. The GZ is a year 2000, and the scooter is a 2007. I expect I need two batteries. This has been discussed much, but I still would appreciate any opinions. Does any vendor double up on shipping and save us some money? I am on a budget that is equilavent to the US Government. I am nearby to AutoZone, PepBoys, NAPA, O'Rileys, and others.
Thanks to all,
John D.



Login or Register to Remove Ads
johnd is offline  
Reply With Quote
Old 02-21-2010, 12:59 PM   #16
Easy Rider
Senior Member
 
Join Date: May 2007
Location: Champaign, Illinois
Posts: 4,561
Re: Starting the Bike effectively

Quote:
Originally Posted by johnd
I jumped it off with lawnmower cables.
Sometime soon you need a small battery charger or tender.....really.

They can be had for about $20. Both your batteries might survive another year if given a good charge......although the 2000 model certainly needs one if it is the original in there.

Keeping the batteries fully charged while in "storage" will greatly lengthen their life (usually).......but that doesn't necessarily mean keeping a tender connected ALL the time.

Some of the online battery vendors offer free shipping on orders of more than XXX dollars from time to time. Plug "motorcycle battery" into your favorite search engine......and then compare the results with those local stores.

If you can possibly afford it, an AGM battery is highly recommended over a conventional wet-cell type. They typically have twice to three times the life span.
__________________
Loud pipes risk rights!
Easy Rider is offline  
Reply With Quote
Old 02-27-2010, 01:08 PM   #17
johnd
Junior Member
 
Join Date: Jun 2009
Location: charlotte, nc
Posts: 18
Re: Starting the Bike effectively

Thank you Easy.
johnd is offline  
Reply With Quote
Old 02-27-2010, 07:42 PM   #18
primal
Senior Member
 
Join Date: Jun 2008
Location: Hurricane, WV
Posts: 446
Send a message via AIM to primal
Re: Starting the Bike effectively

Quote:
Originally Posted by Easy Rider
Sometime soon you need a small battery charger or tender.....really.

They can be had for about $20.
Harbor Freight. $12. Works like a charm for me.
primal is offline  
Reply With Quote
Reply




Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 04:02 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.