09-10-2014, 05:18 AM | #1 |
Member
Join Date: Jan 2014
Location: Dublin, Ireland
Posts: 42
|
Gear shift lever and "what's that noise?" Question
Hi guys and gals, I have 2 questions!
Firstly, the gear shift lever has seemingly gained a LOT of play movement... from right to left. The linkage is also a bit loose, it can be twisted a fair bit, as if rolling a smoke. No problem changing gear or anything like that but I am concerned if I leave this be it may come loose altogether. I had a look and there doesn't seem to be any nuts or bolts apart from the ones where it attaches to the bike, is there a specific way to tighten up or is it ok? Secondly, when I wheel the bike forward there is a "slicing" sound coming from the back wheel area, it seems to be every 1/4 or 1/3 revolution of the wheel. Not much info to go on, but looking at the manual I am thinking it could be something caught in the drum... has anyone experienced this before or have some ideas I can check out? Thanks! Login or Register to Remove Ads |
|
09-11-2014, 06:42 PM | #2 |
Senior Member
Join Date: Dec 2006
Location: Squamish B.C Canada
Posts: 11,409
|
The gear shift linkage is designed to twist. There is a ball on either end under the little rubber booties and they like a quick squirt of change lube every oil change.
Could be rear brake noise. Did you do a chain adjust recently and then notice the noise. If so you just need to back off the adjuster on the brake rod a wee bit. |
|
09-14-2014, 01:18 PM | #3 |
Member
Join Date: Jan 2014
Location: Dublin, Ireland
Posts: 42
|
Thanks WW2.
The noise was always there actually, i just never had the time to look into it. Ill check all of the rods and nuts to check if any changes i make change anything. Sent from my iPhone using Tapatalk Login or Register to Remove Ads |
|
09-14-2014, 05:28 PM | #4 |
Senior Member
Join Date: Dec 2006
Location: Squamish B.C Canada
Posts: 11,409
|
Just remember there will always be a slight noise from the front pads as you push the bike around. It is just the design of disc brakes and not something to panic over. Been there, done that.
|
|
09-17-2014, 12:42 PM | #5 |
Member
Join Date: Jan 2014
Location: Dublin, Ireland
Posts: 42
|
Thanks WW2,
I can't figure this one out on my own (its difficult to wheel the bike and put my ear to the back wheel at the same time ), heading over to a buddys place at the weekend, he can help me pinpoint this noise location and hopefully resolve! Login or Register to Remove Ads |
|
09-17-2014, 07:24 PM | #6 |
Senior Member
Join Date: Dec 2006
Location: Squamish B.C Canada
Posts: 11,409
|
Just rig something to lift the rear wheel off the ground.
|
|
|
|