06-02-2013, 03:41 PM
|
#1 |
|
Junior Member
Join Date: Jun 2013
Location: Rome, Italy
Posts: 3
|
Bent gear shift lever
Hey everyone!
Yesterday I was riding home when a guy in front of me suddenly and violently braked without any reason on an empty street, as a beginner I think I've pulled too much on the brake and fell. I think the guy saw me as he stopped soon after I fell, but kept going as soon as I got up... Well I got up with no harm, but the gearshift lever has completely bent on itself and shifting is a pain. Can I try to bend it back with some heat and hammering, or should I buy a new one? In the latter case, is it a specific model or are there any "aftermarket" lever I could buy?
__________________
Ever tried. Ever failed. No matter. Try again. Fail again. Fail better. Login or Register to Remove Ads |
|
|
|
06-02-2013, 03:50 PM
|
#2 |
|
Senior Member
Join Date: Nov 2008
Location: Tenerife (Spain)
Posts: 3,719
|
Re: Bent gear shift lever
You can but try to bend it back. If you can do it, ok. If not, you haven't lost anything. I've done the same with the brake pedal when the bike went down. At worst, you can still ride while the new one arrives. :2tup:
BTW, you shouldn't need heat - just a 4lb lump hammer.
__________________
By birth an Englishman, by the grace of God a Yorkshireman. |
|
|
|
|
06-02-2013, 03:58 PM
|
#3 | |
|
Junior Member
Join Date: Jun 2013
Location: Rome, Italy
Posts: 3
|
Re: Bent gear shift lever
Quote:
Thanks! 
__________________
Ever tried. Ever failed. No matter. Try again. Fail again. Fail better. Login or Register to Remove Ads |
|
|
|
|
 |
|
|
Linear Mode
