Register Community Calendar Today's Posts Search

Go Back   GZ 250 Forums > GZ250-Specific > Troubleshooting

Reply
 
Thread Tools Display Modes
Old 05-20-2014, 01:42 AM   #1
kmrcstintn
Member
 
Join Date: Apr 2012
Location: Palmyra, PA
Posts: 33
burnt oil smell...

hello...recently got an ultra clean 2009 GZ250 with a bit over 1500 miles; during a ride I had a worrysome incident which might be related to a burnt oil odor that I smell after a decently long run; the incident...a battery tender lead fell out from the side panel below the seat and got caught in the throttle assembly; this caused the throttle to be jammed open and the rpm's were really high after pulling in the clutch at a stop light...this lasted for @ 15-20 seconds until I could shut off the ignition;

I did an oil change...put 1300 ml of oil in with a new filter; when I inspected the filter that was in the engine I noticed some shiny bits (guessing aluminum) as well as in the drained oil; I do not think that I overfilled the oil during the oil change & now I have a light burnt oil odor after running the bike for a fairly long run...otherwise the bike runs good, but I worry about inadvertant damage;

did the piston get scuffed? did I damage something to allow oil to bypass rings into the combustion chamber? is my GZ destined for an early grave?!?



Login or Register to Remove Ads

Last edited by kmrcstintn; 05-20-2014 at 09:51 AM.
kmrcstintn is offline  
Reply With Quote
Old 05-20-2014, 08:12 AM   #2
blaine
Senior Member
 
blaine's Avatar
 
Join Date: Feb 2010
Location: P.E.I. Canada
Posts: 3,784
Sounds like you done some damage when she over revved.I would listen for knocking when started cold,a sign of bottom end damage.
__________________
If at first you do succeed, try not to look surprised.


blaine is offline  
Reply With Quote
Old 05-20-2014, 09:50 AM   #3
kmrcstintn
Member
 
Join Date: Apr 2012
Location: Palmyra, PA
Posts: 33
s**t! that's what I feared...guess a rebuild will be happening a lot sooner than planned; haven't heard any knocking when starting cold...damned thing sounds like an anemic lawn tractor; lol!

but what gives with the burnt oil smell...ring damage?!? oh well...guess I ride it til it goes kaput then decide what to do with it...



Login or Register to Remove Ads
kmrcstintn is offline  
Reply With Quote
Old 05-21-2014, 01:04 AM   #4
5th_bike
Senior Member
 
5th_bike's Avatar
 
Join Date: Oct 2007
Location: HoCo, Maryland
Posts: 1,349
No worries, they probably didn't do the first oil change at 600 miles yet, and the first oil change always shows some metal shavings in the oil filter.

Then, the burnt oil smell is most likely from a little oil spilled on your exhaust pipes, under the engine. It will disappear with a few rides.
__________________
2005 "Saturn Black", stock + tach

Last edited by 5th_bike; 05-21-2014 at 01:05 AM. Reason: removed quote
5th_bike is offline  
Reply With Quote
Old 05-21-2014, 08:20 AM   #5
blaine
Senior Member
 
blaine's Avatar
 
Join Date: Feb 2010
Location: P.E.I. Canada
Posts: 3,784
Quote:
Originally Posted by 5th_bike View Post
No worries, they probably didn't do the first oil change at 600 miles yet, and the first oil change always shows some metal shavings in the oil filter.

Then, the burnt oil smell is most likely from a little oil spilled on your exhaust pipes, under the engine. It will disappear with a few rides.
I sure hope your right 5th.But he did give it a pretty good "over revving"
__________________
If at first you do succeed, try not to look surprised.





Login or Register to Remove Ads
blaine is offline  
Reply With Quote
Old 05-21-2014, 10:23 PM   #6
5th_bike
Senior Member
 
5th_bike's Avatar
 
Join Date: Oct 2007
Location: HoCo, Maryland
Posts: 1,349
Thanks - fingers crossed...
__________________
2005 "Saturn Black", stock + tach
5th_bike is offline  
Reply With Quote
Old 05-22-2014, 12:17 AM   #7
kmrcstintn
Member
 
Join Date: Apr 2012
Location: Palmyra, PA
Posts: 33
doesn't matter...I'll do another oil/filter change @ 2000 miles (currently @ 1900 miles +) to flush more of the crap out; then I ride it til it dies, roll it into a field somewhere and put it out of its misery with a barage of buckshot & slugs...lol!
kmrcstintn is offline  
Reply With Quote
Old 05-22-2014, 09:53 AM   #8
jonathan180iq
Super Moderator
 
jonathan180iq's Avatar
 
Join Date: Jan 2007
Location: Dalton, GA
Posts: 3,996
Don't do that. Parts are valuable. Part out the bike as much as you can and then recycle the metal and stuff that doesn't sell.
jonathan180iq is offline  
Reply With Quote
Old 05-22-2014, 06:30 PM   #9
kmrcstintn
Member
 
Join Date: Apr 2012
Location: Palmyra, PA
Posts: 33
Irate

JOKING!!! I put an extended service plan on the bike when I bought it...if it breaks then it gets fixed like being under warranty with a nominal deductible (also comes with roadside assistance); just ordered a new battery & saddlebag supports for it; I'm running it this weekend and following up with an oil/filter change (flush out the engine again) & cleaning/lubing the chain...oh greasy fun ;-)

just a bit upset that damage could have happened due to a cheap ass who didn't want to spend a few more minutes securing the battery tender lead PROPERLY!!! especially when it took me 7-10 minutes and 2 zip ties...even taping it out of the way would have been better than hanging loosely behind the side plate under the seat...this allowed the lead to fall out while riding and get caught in the throttle assembly on the side of the carburetor; ugh!!!

Last edited by kmrcstintn; 05-22-2014 at 07:36 PM.
kmrcstintn is offline  
Reply With Quote
Reply




Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:39 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.