So I switched to a 16t sprocket...

Shawnski451 · 05-31-2019, 10:19 PM

... and the first thing I noticed was that 1st gear is actually usefull. Lol. Street riding is actually nicer, and 4th gear is actually a decent accelleration gear up past 50 mph.

However, my best mph with the standard 15t gear was 71 mph (revving it's brains out.) But top speed dropped off a quite a bit and I could only grab 64 mph( into a slight head wind). The RPM is definitely lower at 55 and feels smoother. I'm gonna cruise it around town and some back roads before I really form an opinion about this mod.

Vegas Street Rider · 06-01-2019, 12:32 AM

The 16T sprocket will allow a higher top speed but also reduces the torque, so unless you are on the flat with no headwind, the little GZ won't have enough umph to get you up to that faster speed. It's all about compromises. The lower revs will help extend the life of your single cylinder thumper.

Shawnski451 · 06-01-2019, 09:02 AM

Vegas, what gear are you running?

Vegas Street Rider · 06-01-2019, 10:16 AM

41T rear sprocket. Is that what you're asking? Bike is stock except for viking bags with rear seat removed.

Shawnski451 · 06-03-2019, 11:02 PM

Im actually enjoying this 16T sprocket. I'm going to make a motovlog/helmet video as soon as I get the wind/buffeting issue worked out. Still may go back to the 15t sprocket.

wacio · 06-09-2019, 01:02 AM

I would highly doubt you can get higher speeds from 16T setup (maybe downhill). I have stock setup (15t) . I rode today and my top speeds are 50mph in third, 70 in fourth and 82 in fifth. It is very visible that there is not enough torque in fifth to move motorcycle any faster (actually speed drops substantially in top gear with slightest hill or headwind). GZ is not limited by running out off RPMs. At 70 in fourth - engine is running at 8500 and just over 8k in fifth at 82mph.

Donald McPherson · 06-09-2019, 06:48 AM

I can only squeeze a top speed of 62mph But then again I am in the UK and our Marauders are only 125cc. Does nicely for a city runaround or short trips out and about cruising at about 50mph.

GZ300 · 06-18-2021, 09:04 PM

14/37 makes both sprockets lighter and uses less links making the chain lighter as well.

Ya'll just do what everone else does without really thinking about it dontcha.

Jt 434.14
Jt 819.37 usually only available in the UK but whatever.

05-31-2019, 10:19 PM	#1
Shawnski451 Member Join Date: Jan 2019 Posts: 32	So I switched to a 16t sprocket... ... and the first thing I noticed was that 1st gear is actually usefull. Lol. Street riding is actually nicer, and 4th gear is actually a decent accelleration gear up past 50 mph. However, my best mph with the standard 15t gear was 71 mph (revving it's brains out.) But top speed dropped off a quite a bit and I could only grab 64 mph( into a slight head wind). The RPM is definitely lower at 55 and feels smoother. I'm gonna cruise it around town and some back roads before I really form an opinion about this mod. Login or Register to Remove Ads
	0

06-01-2019, 09:02 AM	#3
Shawnski451 Member Join Date: Jan 2019 Posts: 32	Vegas, what gear are you running? Login or Register to Remove Ads
	0

06-01-2019, 10:16 AM	#4
Vegas Street Rider Senior Member Join Date: May 2015 Location: Henderson, NV Posts: 1,108	41T rear sprocket. Is that what you're asking? Bike is stock except for viking bags with rear seat removed. Last edited by Vegas Street Rider; 06-01-2019 at 10:21 AM.
	0

06-03-2019, 11:02 PM	#5
Shawnski451 Member Join Date: Jan 2019 Posts: 32	Im actually enjoying this 16T sprocket. I'm going to make a motovlog/helmet video as soon as I get the wind/buffeting issue worked out. Still may go back to the 15t sprocket. Login or Register to Remove Ads
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

06-01-2019, 12:32 AM	#2
Vegas Street Rider Senior Member Join Date: May 2015 Location: Henderson, NV Posts: 1,108	The 16T sprocket will allow a higher top speed but also reduces the torque, so unless you are on the flat with no headwind, the little GZ won't have enough umph to get you up to that faster speed. It's all about compromises. The lower revs will help extend the life of your single cylinder thumper.
	0

06-09-2019, 01:02 AM	#6
wacio Senior Member Join Date: Apr 2016 Location: Illinois Posts: 174	I would highly doubt you can get higher speeds from 16T setup (maybe downhill). I have stock setup (15t) . I rode today and my top speeds are 50mph in third, 70 in fourth and 82 in fifth. It is very visible that there is not enough torque in fifth to move motorcycle any faster (actually speed drops substantially in top gear with slightest hill or headwind). GZ is not limited by running out off RPMs. At 70 in fourth - engine is running at 8500 and just over 8k in fifth at 82mph.
	0

06-09-2019, 06:48 AM	#7
Donald McPherson Member Join Date: Aug 2018 Location: Aberdeen Scotland Posts: 47	I can only squeeze a top speed of 62mph But then again I am in the UK and our Marauders are only 125cc. Does nicely for a city runaround or short trips out and about cruising at about 50mph.
	0

06-18-2021, 09:04 PM	#8
GZ300 Junior Member Join Date: Jun 2021 Posts: 25	14/37 makes both sprockets lighter and uses less links making the chain lighter as well. Ya'll just do what everone else does without really thinking about it dontcha. Jt 434.14 Jt 819.37 usually only available in the UK but whatever.
	0