![]() |
#1 |
Member
Join Date: May 2010
Location: Bristol,CT, USA
Posts: 73
|
![]()
Went for a ride yesterday, about 30 miles, then as I headed home about a block away from home, my bike just cut out, stalled, and I had a dead battery. Pushed it home, oh boy. Had the battery checked after charging it and it was okay. I reinstalled it, and started it, but as I gave it some throttle shouldn't the needle on my gauge go up? It didn't. Could I have a bad generator. How can I check it and how difficult is it to change if it is bad? What else could it be? I appreciate any help.
Login or Register to Remove Ads |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2015
Location: Stafford, Texas
Posts: 604
|
Charge system simple.
Magnets spin around stator to make 3 phase ac. ac rectified by 6 diodes in r&r unit the scr's in r&r unit regulate charge by dumping excess current. Rest gets sent to battery to maintain 13.someodd volts while bike runs. 13.8 ish What is volts at fully charged battery fresh after start? At this point stator, wiring, r&r, and more wiring are suspect. |
![]() |
![]() |
![]() |
#4 |
Junior Member
Join Date: Sep 2014
Location: Stafford Co., VA
Posts: 12
|
There is a slightly older thread on the forum that may help:http://www.gz250bike.com/forum/showthread.php?t=7499
see post number 9 which refers to:http://www.thegsresources.com/statorpapers.php In the stator papers, they cover testing and if you are up to it and need a new stator, a stator rewind. chuck Last edited by steelerdude99; 07-25-2015 at 04:25 PM. |
![]() |
![]() |
![]() |
#6 |
Member
Join Date: May 2010
Location: Bristol,CT, USA
Posts: 73
|
I thank you both for the help. I don't have all the necessary equipment to check for problems. After seeing your advice, and the way it was not charging correctly, I brought the bike to a dealer. He checked out the charging system and found a ground short from the stator so I ok'd him to replace it and the regulator. I don't have enough experience to do it. If it was a little simpler I would attempt it. I'll let you know how it works out after the repair which is set for next Thursday.
|
![]() |
![]() |
![]() |
#7 | |
Junior Member
Join Date: Sep 2014
Location: Stafford Co., VA
Posts: 12
|
Quote:
chuck |
|
![]() |
![]() |
![]() |
#8 |
Senior Member
Join Date: Nov 2008
Location: Tenerife (Spain)
Posts: 3,719
|
Guess I'm lucky. Over here the labour rate is €25 (around $27.50) an hour.
__________________
By birth an Englishman, by the grace of God a Yorkshireman. |
![]() |
![]() |
![]() |
#9 | |
Junior Member
Join Date: Sep 2014
Location: Stafford Co., VA
Posts: 12
|
Quote:
chuck |
|
![]() |
![]() |
![]() |
#10 |
Member
Join Date: May 2010
Location: Bristol,CT, USA
Posts: 73
|
You're probably right but $450 is better than $4500 right now. Hope I don't need more repairs and maybe I'll get a new one in a few years.
|
![]() |
![]() |
![]() |
|
|