Anyone put 1” bars on their GZ?

raddad70 · 06-04-2020, 08:15 PM

I will be doing this to my rat bobber-esque bike. Maybe overkill but I bought a 1” Biltwell mustache bar super cheap so that’s the reason why. It’s nice and heavy and low profile so I will use some 4” risers to keep height about the same. I want to fill with shot and maybe have reduced vibration. I dremeled the left hand control already and it fits fine. Choke lever is very stiff and needs more work - getting a little thin and flimsy from material I had to remove. Clutch and brake master cylinder will need replaced to fit the larger bar but I was going to do this anyway. Both levers were jacked and leaking brake fluid. I can get a cheap Chinese set off fleabay for $40. May be awhile before this is done and will take pictures. Just wondering if anyone has done this before?

06-04-2020, 08:15 PM	#1
raddad70 Junior Member Join Date: May 2020 Posts: 23	Anyone put 1” bars on their GZ? I will be doing this to my rat bobber-esque bike. Maybe overkill but I bought a 1” Biltwell mustache bar super cheap so that’s the reason why. It’s nice and heavy and low profile so I will use some 4” risers to keep height about the same. I want to fill with shot and maybe have reduced vibration. I dremeled the left hand control already and it fits fine. Choke lever is very stiff and needs more work - getting a little thin and flimsy from material I had to remove. Clutch and brake master cylinder will need replaced to fit the larger bar but I was going to do this anyway. Both levers were jacked and leaking brake fluid. I can get a cheap Chinese set off fleabay for $40. May be awhile before this is done and will take pictures. Just wondering if anyone has done this before? Login or Register to Remove Ads
	0