![]() |
#21 | |
Senior Member
Join Date: Dec 2006
Location: Squamish B.C Canada
Posts: 11,409
|
Re: My GZ 's top speed seems low
Quote:
Login or Register to Remove Ads |
|
![]() |
![]() |
![]() |
#22 |
Junior Member
Join Date: Aug 2012
Location: South Eastern Pennsylvania
Posts: 13
|
Re: My GZ 's top speed seems low
I checked for a leak and couldn't find one. Checked all of the hoses and sprayed some WD 40 on the boots and connections. The throttle grip does close smoothy by itself.
|
![]() |
![]() |
![]() |
#24 |
Senior Member
Join Date: Apr 2012
Location: Elkhart, Indiana
Posts: 369
|
Re: My GZ 's top speed seems low
|
![]() |
![]() |
![]() |
#25 | ||
Super Moderator
Join Date: Jan 2007
Location: Dalton, GA
Posts: 3,996
|
Re: My GZ 's top speed seems low
Quote:
Or People have also complained of the carb boots (the rubber things that connect the carb to the engine) not being tight enough and letting in way too much air. Login or Register to Remove Ads |
||
![]() |
![]() |
![]() |
#26 |
Senior Member
Join Date: Jan 2008
Location: Crawfordville, Florida
Posts: 2,853
|
Re: My GZ 's top speed seems low
You said a number of posts above that you turned "that screw thing" and increased the idle because your biker stalled. You probably adjusted it too high, and that wasn't your initial problem anyway. That idle adjustment screw is only to be used when the engine has fully warmed up, and then set to about 1300 rpms, then you don't touch it again. Ride your bike, warm it up, and turn down that white knob until the idle sounds right, then leave it alone.
And make sure you are also not riding around with the choke on. You may need the choke to start the bike after it sits a while and this is normal and may be why your bike would only run for a second and then stall, being up in cold Pennsylvania. As you ride and the engine warms up, slowly turn it down 'till it is off after a few minutes or about 1 mile of riding. If you haven't yet, read the owners manual and it will answer and solve a lot of problems before you start making new ones. It can be downloaded off here if you don't have one. |
![]() |
![]() |
![]() |
#27 |
Junior Member
Join Date: Jun 2016
Posts: 10
|
I just picked up my GZ a week ago. I just got it over 65 for the first time and I have to admit I was a bit anxious. About how long are you able to hold 70+?
|
![]() |
![]() |
![]() |
#28 |
Senior Member
Join Date: May 2015
Location: Henderson, NV
Posts: 1,098
|
I installed a 16 tooth front sprocket and can reach 80 mph on my GZ barring any wind or hills, but with the stock 15 tooth front sprocket you should easily cruise at 60 mph for extended trips with the same caveats. Just remember that you are creating a lot of wear and tear on that single cylinder engine at those higher revs. Safe riding.
|
![]() |
![]() |
![]() |
|
|