Electrical issues and a brake question, need help - Page 2

Water Warrior 2 · 04-20-2013, 04:28 AM

Quote:

Originally Posted by mole2

Quote:

Originally Posted by alantf

Quote:

Originally Posted by kyraeus

he calmly, quietly, flipped the two main cables I had hooked up to the solenoid, turned the key, and smiled silently at me while the turn signals flashed and the neutral light came on.

Can you explain exactly what you mean, because I don't quite understand? So long as the two HT (thick) cables go to the two HT terminals (and I can't see where else they'd fit) then it shouldn't matter which way round they go. All that happens when you energise the coil is that the main contact closes and shorts the two cables together, allowing power to flow to the starter motor. :??:

I don't know about this particular relay but some relays have the hot side of the secondary winding tapped off of the battery cable side of the primary contacts internally. The negative is then used as the switch side make/break. If you have the cables reversed there is no positive feed for the secondary winding. That could be the case here.

Yup, putting the switch in the on position provides the ground.
That would be similar to interior lights in a cage. Opening the door lets the little button pop out of the door frame and provide a ground to complete the circuit.

alantf · 04-20-2013, 05:28 AM

I live and learn. :blush:

Water Warrior 2 · 04-20-2013, 07:01 PM

Quote:

Originally Posted by alantf

I live and learn. :blush:

Alan, are you saying you didn't know something electrical? We may have to re-evaluate your guru statis. :lol: Just kidding, we would often be in deep doo-doo without you and your experience.

alantf · 04-21-2013, 05:23 AM

Looking at the circuit drawing again, I can see that the coil circuit is connected to the thick cable from the battery. My mind was seeing two separate circuits (not really looking at the drawing, because I knew (or thought I knew :blush: ) the solenoid circuit). That'll teach me to check the circuits CAREFULLY! :oops:

04-20-2013, 05:28 AM	#12
alantf Senior Member Join Date: Nov 2008 Location: Tenerife (Spain) Posts: 3,719	Re: Electrical issues and a brake question, need help I live and learn. :blush: __________________ By birth an Englishman, by the grace of God a Yorkshireman.
	0

04-21-2013, 05:23 AM	#14
alantf Senior Member Join Date: Nov 2008 Location: Tenerife (Spain) Posts: 3,719	Re: Electrical issues and a brake question, need help Looking at the circuit drawing again, I can see that the coil circuit is connected to the thick cable from the battery. My mind was seeing two separate circuits (not really looking at the drawing, because I knew (or thought I knew :blush: ) the solenoid circuit). That'll teach me to check the circuits CAREFULLY! :oops: __________________ By birth an Englishman, by the grace of God a Yorkshireman.
	0