Maxing out at 40mph

Jalket · 05-26-2018, 11:22 AM

Good Morning Everyone,

My GZ250 is not moving like it used to, i had been riding it everyday, had a problem with the bike dying while riding so i cleaned the carb and it started running again but came back with a different problem - The Speed.

It used to get up and go, i mean it was fun and a little fast cruiser. Now it just takes its sweet time to go and maxes out at 40.

Air filters clean, carbs clean, seals are tight, battery is good, hoses are fine. Don't know what else i can do.

I did read in a different forum that it might be Lash Adjusters and i have no idea about those. Anyone else go through this before ?

suzukix668 · 07-30-2018, 05:13 PM

HI have you check the valves intake & ex. you may have the jets mix up or the carb not put together right. valve adj is intake .03 .08 MM ex is .08 1.3 MM I set mine to, in .05 MM ex 1.0MM

winglem · 04-30-2019, 10:05 AM

The main jet and idle jet might be switched in the wrong place. They look the same but make sure the main jet going to the needle is the bigger hole.

5th_bike · 05-14-2019, 04:25 PM

Don't wait too long with the valve adjustment.

05-26-2018, 11:22 AM	#1
Jalket Junior Member Join Date: May 2018 Posts: 3	Maxing out at 40mph Good Morning Everyone, My GZ250 is not moving like it used to, i had been riding it everyday, had a problem with the bike dying while riding so i cleaned the carb and it started running again but came back with a different problem - The Speed. It used to get up and go, i mean it was fun and a little fast cruiser. Now it just takes its sweet time to go and maxes out at 40. Air filters clean, carbs clean, seals are tight, battery is good, hoses are fine. Don't know what else i can do. I did read in a different forum that it might be Lash Adjusters and i have no idea about those. Anyone else go through this before ? Login or Register to Remove Ads
	0

04-30-2019, 10:05 AM	#3
winglem Junior Member Join Date: Apr 2019 Posts: 7	The main jet and idle jet might be switched in the wrong place. They look the same but make sure the main jet going to the needle is the bigger hole. Login or Register to Remove Ads
	0

05-14-2019, 04:25 PM	#4
5th_bike Senior Member Join Date: Oct 2007 Location: HoCo, Maryland Posts: 1,349	Don't wait too long with the valve adjustment. __________________ 2005 "Saturn Black", stock + tach
	0

07-30-2018, 05:13 PM	#2
suzukix668 Junior Member Join Date: Nov 2010 Location: la ca Posts: 23	HI have you check the valves intake & ex. you may have the jets mix up or the carb not put together right. valve adj is intake .03 .08 MM ex is .08 1.3 MM I set mine to, in .05 MM ex 1.0MM
	0