Handlebars. Additional Assy?

[jonathan180iq]

Originally Posted by mrlmd1

Last thought - Make sure you get the right size (7/8") before you cut the old ones off.

:plus1:

[Black Warrior]

http://www.ebay.ca/itm/Handle-Bar-Hand- ... 500wt_1156

I got the same ones only from a guy in Florida, it was $25 shipping included. I'm quite happy with those. (Honestly I had not expected a good grip before I got 'em)

[blaine]

Originally Posted by Black Warrior

I got the same ones only from a guy in Florida, it was $25 shipping included. I'm quite happy with those. (Honestly I had not expected a good grip before I got 'em)

I have had these grips on two different bikes,and I'm very satisfied with them.
:2tup:

[Rookie Rider]

When taking off old grips, whAt do you do with that plastic sleeve? And what if youre putting new bars on?

[Water Warrior 2]

The plastic sleeve is part of the throttle assembly. The entire assembly slides off the end of the bar after you loosen the screws that hold it tight. The 2 throttle cables go into the assembly.

[blaine]

Originally Posted by Rookie Rider

When taking off old grips, whAt do you do with that plastic sleeve? And what if youre putting new bars on?

Most aftermarket grips fit over the throttle sleeve.If you look at them closely,one is a little larger than the other.When removing the old grips just be careful not to damage the throttle sleeve.The throttle sleeve stays in place.The new one will slide on over the sleeve.
:cool:

[Rookie Rider]

Ok great, thank you.