Rear Axle Replacement

Vegas Street Rider · 03-18-2022, 02:14 PM

I over- torqued the nut on my rear axle and stripped the threads on it and am about to replace it.

My question is, does the new/used axle need to be greased before installing?

Any other suggestions as to how to make it easiest to do will be appreciated.

Thanks.

Vegas Street Rider · 03-24-2022, 02:23 AM

I guess it pays to do your own research. Disregard my previous post.

Vegas Street Rider · 03-28-2022, 08:31 PM

Replaced the axle without any problems. While I was at it, I inspected the brake pads and cleaned out the brake dust, cleaned and inspected the sprockets for wear, checked and cleaned the spokes.

I replaced the chain and adjusted it and tightened the axle to specs. I also changed the oil and filter.

After all that, I cleaned the bike up and polished the aluminum, waxed the fuel tank, and polished the fenders and chrome.

I am pretty much ready to do some more riding once the weather is a bit more conducive for enjoyment. The winds have been intense here lately. Safe riding everyone.

EddieSC · 04-02-2022, 03:34 AM

Yeah any time I have a moving part like that out, I grease it before reinstallation. So far it's a rule that's served me well!

Glad to hear your GZ got some TLC. I've got a few parts to fabricate for mine before she's where I want her but I can't wait for my first downtown cruise with her!

03-18-2022, 02:14 PM	#1
Vegas Street Rider Senior Member Join Date: May 2015 Location: Henderson, NV Posts: 1,108	Rear Axle Replacement I over- torqued the nut on my rear axle and stripped the threads on it and am about to replace it. My question is, does the new/used axle need to be greased before installing? Any other suggestions as to how to make it easiest to do will be appreciated. Thanks. Login or Register to Remove Ads
	1

03-28-2022, 08:31 PM	#3
Vegas Street Rider Senior Member Join Date: May 2015 Location: Henderson, NV Posts: 1,108	Replaced the axle without any problems. While I was at it, I inspected the brake pads and cleaned out the brake dust, cleaned and inspected the sprockets for wear, checked and cleaned the spokes. I replaced the chain and adjusted it and tightened the axle to specs. I also changed the oil and filter. After all that, I cleaned the bike up and polished the aluminum, waxed the fuel tank, and polished the fenders and chrome. I am pretty much ready to do some more riding once the weather is a bit more conducive for enjoyment. The winds have been intense here lately. Safe riding everyone. Login or Register to Remove Ads
	1

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

03-24-2022, 02:23 AM	#2
Vegas Street Rider Senior Member Join Date: May 2015 Location: Henderson, NV Posts: 1,108	I guess it pays to do your own research. Disregard my previous post.
	1

04-02-2022, 03:34 AM	#4
EddieSC Member Join Date: May 2010 Location: Birmingham, AL Posts: 37	Yeah any time I have a moving part like that out, I grease it before reinstallation. So far it's a rule that's served me well! Glad to hear your GZ got some TLC. I've got a few parts to fabricate for mine before she's where I want her but I can't wait for my first downtown cruise with her!
	1