gz 250 wont rev up

[22matt22]

i have a 2003 gz250 an when i got the bike it didnt run it sat up for a wile i cleaned the carb like 4 times then had it boild as they coaled it an it starts up i road it down the streat then killed it the next day i started it up an idels but its idled hight but when u give it a lilbit of thotel it will idel like it supost to but if u keep puling the thotel it dies i have checked the valves the petcock every thing is clean an right does any one know y on earth its doing this i just dont under stand it

[JWR]

Are you typing this on a smart phone??
Is English your first language??

Will the bike run long enough to set the idle with the white knob?

[jonathan180iq]

After a good cleaning, you're going to need to set your idle again, like JWR just mentioned.
Were all of the standard jets retained? I mean, nothing was changed from stock, right?

Check your throttle cable tension and your choke cable. Make sure they aren't hanging somewhere.

That was the hardest read of my life. Periods are your friend.

[alantf]

Originally Posted by jonathan180iq

Periods are your friend.

Errrrrr...... :blush: ....In England, they're......errrrr.....women's....like..... monthly things. :blush:

So as not to get confused, the dots at the end of sentences are "full stops".

[jonathan180iq]

In the States, we call them ellipses.

[22matt22]

sorry about the spelling an the bad punction im dislexic so sorry. well any way with no thotel on it, it does the same thing. also with the thotel screw backed out it still does it with it not tuching. aslo the mixer screw it does not make any difference were it is. it does not change at all. with the choke brass pice off an just stuck in the choke hole then with the choke screwed in u have a quater of the thotel. but there is no air leaks, so its got to do some thing with the carb right

[22matt22]

ok new problem i got the bike runing an driving but only half the throtel. first an secon r ok thers not a lot of power to it at all an at full speed in 3erd it only goes 30 mph. so theres a loss of power an its like it has no top ened what could it be

[raul10141964]

the slider on the carb may bi sticky or the diaphragm damage

[jonathan180iq]

Matt, if you play with the idle set and the throttle screw too much it can be hard to get them back to where they should be once your carb is healthy.

Has the bike been sitting for a long time? Are you just breaking it out for the Spring? If so, you need to give the carb a good cleaning. If you didn't drain the gas or treat it with something before storing it, the carb will have varnished and is likely the cause of this whole issue.

[alantf]

Originally Posted by jonathan180iq

If you didn't train the gas or treat it

Mine knew what to do, instinctively. But I bought it a beer. :crackup :crackup