I screwed up!

spasm3 · 12-04-2011, 03:02 PM

While riding the timing view bolt on top of the left cover vibrated out, it was spewing oil out. i was near a parts store and was able to get a bolt to put in there. The bolt was a bit long and i slightly bumped the starter as i was worried about it , i heard it hit. I backed it way out and now the bike will not run. it started once and ran rough , sounded like it was out of time. I'm going to trailer it home. What did i break?

blaine · 12-04-2011, 04:29 PM

I think when you screwed the bolt in too far you hit the flywheel & damaged it.This would cause it to be out of time & run rough.You will be able to see once you remove the side cover.Also check that the stator did not get damaged.
:cool:

12-04-2011, 03:02 PM	#1
spasm3 Junior Member Join Date: Jun 2011 Location: north carolina Posts: 10	I screwed up! While riding the timing view bolt on top of the left cover vibrated out, it was spewing oil out. i was near a parts store and was able to get a bolt to put in there. The bolt was a bit long and i slightly bumped the starter as i was worried about it , i heard it hit. I backed it way out and now the bike will not run. it started once and ran rough , sounded like it was out of time. I'm going to trailer it home. What did i break? Login or Register to Remove Ads
	0

12-04-2011, 04:29 PM	#2
blaine Senior Member Join Date: Feb 2010 Location: P.E.I. Canada Posts: 3,784	Re: I screwed up! I think when you screwed the bolt in too far you hit the flywheel & damaged it.This would cause it to be out of time & run rough.You will be able to see once you remove the side cover.Also check that the stator did not get damaged. :cool: __________________ If at first you do succeed, try not to look surprised.
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode