07-27-2010, 01:47 AM | #31 |
Senior Member
Join Date: May 2010
Location: Abbotsford, BC
Posts: 444
|
Re: joel procrastinated about 4 months, then posted his bike
Oops!! Sorry Joel, I meant I mount my windshield just above the speedo! If I could mount it higher I would. When I crouch down a little in the saddle the wind noise is diminished so I'm sure it's caused by the wind spilling over the top, not underneath. I'm still playing with the angle to see if I can improve it. Can't say I'm very impressed with the mounting brackets, they tend to loosen up on the 'struts' when I go over too many bumps. I'm going to replace the winghead screws with lock nuts. Anyway, here's my setup. YMMV
Good luck!
__________________
Lovin' every minute of it. 2005 GZ250 (sold after 26000km) 2013 CB500XA Login or Register to Remove Ads |
|
07-27-2010, 09:12 AM | #32 | |
Senior Member
Join Date: Feb 2010
Location: P.E.I. Canada
Posts: 3,784
|
Re: joel procrastinated about 4 months, then posted his bike
Quote:
:smallrawk: |
|
|
07-27-2010, 10:29 AM | #33 | |
Senior Member
Join Date: May 2007
Location: Champaign, Illinois
Posts: 4,561
|
Re: joel procrastinated about 4 months, then posted his bike
Quote:
While what you say is logical and probably is true, there IS a point where the offending air shifts from top to bottom and it is not always easy to recognize when that happens. The bottom air sometimes hits your chest at just the right angle to run up your body and beat on your helmet........and leaning forward (and down) a bit disrupts that perfect angle......in a fashion very similar to dropping your head out of the top stream. I post this not to dispute your analysis of the situation but to just point out what has happened to ME and LOTS of other ridres too when trying to adjust shields. It took me YEARS and lots of people beating it into my head before I finally "got it". (Yes, thick headed !!)
__________________
Loud pipes risk rights! Login or Register to Remove Ads |
|
|
07-27-2010, 10:58 AM | #34 |
Senior Member
Join Date: May 2007
Location: New Port Richey, Florida USA
Posts: 1,348
|
Re: joel procrastinated about 4 months, then posted his bike
IMHO, windshields work best (at least for me) when close to the headlight, as wide as functionally possible, and at the same angle as the forks.
The added width seems to stop most side buffeting. There are differing opinions as to whether to look over or through it. Most folks (as far as I can tell), as well as myself, look over the windshield. Most folks do agree that the Spitfire and similar two point mounted windshields are too small, poorly mounted, and marginally effective at best. I have a fork mounted police style windshield as shown below and I wish it was 1-1/2" to 2" taller. I bought the tallest available (15") and it's about 85% efficient for my need but is more than adequate.
__________________
Prudent riders live longer than moron riders. |
|
07-27-2010, 02:29 PM | #35 | |
Senior Member
Join Date: May 2007
Location: Champaign, Illinois
Posts: 4,561
|
Re: joel procrastinated about 4 months, then posted his bike
Quote:
With the built-in lowers, it looks to me like you could afford to do that without creating a lower problem.
__________________
Loud pipes risk rights! Login or Register to Remove Ads |
|
|
07-27-2010, 03:20 PM | #36 |
Senior Member
Join Date: May 2007
Location: New Port Richey, Florida USA
Posts: 1,348
|
Re: joel procrastinated about 4 months, then posted his bike
If I move it up, it leaks too much air around the headlight & looks kinda goofy.
__________________
Prudent riders live longer than moron riders. |
|
07-27-2010, 04:35 PM | #37 |
Senior Member
Join Date: May 2010
Location: Abbotsford, BC
Posts: 444
|
Re: joel procrastinated about 4 months, then posted his bike
I hear what you're saying, Easy; no arguments here. A bigger shield would be better for me. It's not annoying me too much so I'll just keep playing with it.
__________________
Lovin' every minute of it. 2005 GZ250 (sold after 26000km) 2013 CB500XA |
|
07-28-2010, 05:28 PM | #38 | |
Senior Member
Join Date: May 2010
Location: Phoenix, AZ
Posts: 180
|
Re: joel procrastinated about 4 months, then posted his bike
Quote:
AZ Kev
__________________
ATGATT - Road rash sucks, and the asphalt doesn't care how "cool" you look... |
|
|
07-31-2010, 12:37 AM | #39 |
Junior Member
Join Date: Jul 2010
Location: burnsville, mn
Posts: 13
|
Re: joel procrastinated about 4 months, then posted his bike
Ok! Above are pictures of what my windshield looks like after tinkering with it as much as I will allow myself to. I know it isn't perfect, but it gets to a point where I will just be adjusting it forever and never be satisfied. I went for a short ride after and brought it up to speed. It actually blocks the wind from hitting my face directly and instead I have a steady stream of air hitting the top of my face evenly, but not the usual force that pushes you backwards. It does make the shield work harder, since the wind is pushed slightly upwards versus flush with the forks. This makes me worry that I may have to constantly readjust it. Remains to be seen. On a side note, I dropped my helmet from the top of my bike to the pavement several times and I no longer felt comfortable riding with it, so I picked up the same model helmet in black... and I picked up a really nice Scorpion jacket and thought I'd show it off. I love it. :2tup: |
|
07-31-2010, 01:13 AM | #40 |
Senior Member
Join Date: Feb 2010
Location: P.E.I. Canada
Posts: 3,784
|
Re: joel procrastinated about 4 months, then posted his bike
|
|
Thread Tools | |
Display Modes | |
|
|