Replacing the Front Master Cylinder Sight Glass, Anyone? - Page 3

**jonathan180iq** · 10-03-2011, 09:59 AM

I've used a dime and some epoxy stuff called QuickSteel.

I'll take a photo in a bit.

It's holding up great is all types of weather after almost 3 months now.

Jvacustoms · 10-10-2011, 09:41 AM

If it is just a cloudy sight glass just get some fine sand paper and some Meguiar's PlastX http://www.meguiarsdirect.com/product_d ... MEG+G12310

step 1 sand down till u can see that the oxidation of the plastic is either thinner or gone.

step 2 rub with a cloth and some plastx untill the plastic is again smooth and pretty normally about 3-4 applications about 5 minutes...

total time included in job 10 minutes.

10-03-2011, 09:59 AM	#21
jonathan180iq Super Moderator Join Date: Jan 2007 Location: Dalton, GA Posts: 3,996	Re: Replacing the Front Master Cylinder Sight Glass, Anyone? I've used a dime and some epoxy stuff called QuickSteel. I'll take a photo in a bit. It's holding up great is all types of weather after almost 3 months now. Login or Register to Remove Ads
	0

10-10-2011, 09:41 AM	#22
Jvacustoms Senior Member Join Date: Jul 2011 Location: Eatonton, GA Posts: 237	Re: Replacing the Front Master Cylinder Sight Glass, Anyone? If it is just a cloudy sight glass just get some fine sand paper and some Meguiar's PlastX http://www.meguiarsdirect.com/product_d ... MEG+G12310 step 1 sand down till u can see that the oxidation of the plastic is either thinner or gone. step 2 rub with a cloth and some plastx untill the plastic is again smooth and pretty normally about 3-4 applications about 5 minutes... total time included in job 10 minutes.
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode