Go Back   GZ 250 Forums > GZ250-Specific > Instructional Articles

Reply
 
Thread Tools Display Modes
Old 07-24-2008, 11:52 AM   #11
FreyGrimrod
Junior Member
 
Join Date: Jun 2008
Posts: 15
Umm... shouldn't the amperage pose a possible issue off a car battery? Shouldn't one have some additional draw off the average car battery like the headlights on in the car when approaching the tiny wiring of our little GZ250's? I considered jumping my bike once but luckily managed to get it to start just by detaching the battery bringing it inside out of the cold for a while to warm up and putting it back on the bike then giving it a go.



Login or Register to Remove Ads
FreyGrimrod is offline  
Reply With Quote
Old 07-27-2008, 09:37 AM   #12
Badbob
Senior Member
 
Badbob's Avatar
 
Join Date: Aug 2006
Location: Tallahassee FL
Posts: 945
Quote:
Originally Posted by FreyGrimrod
Umm... shouldn't the amperage pose a possible issue off a car battery? Shouldn't one have some additional draw off the average car battery like the headlights on in the car when approaching the tiny wiring of our little GZ250's? I considered jumping my bike once but luckily managed to get it to start just by detaching the battery bringing it inside out of the cold for a while to warm up and putting it back on the bike then giving it a go.
No
Ohm's Law will explain it.
Badbob is offline  
Reply With Quote
Old 05-20-2010, 10:15 PM   #13
magnum44270
Member
 
Join Date: May 2010
Location: Cabot ,Ar. Wisconsin at heart
Posts: 65
Re: Push start your GZ.

did this 2 night ago, leaving work! left the key on....... put her in 2, gave a good push, hoped on, popped clutch, fired, gave gas..vroom-vroom!



Login or Register to Remove Ads
magnum44270 is offline  
Reply With Quote
Old 05-20-2010, 10:39 PM   #14
magnum44270
Member
 
Join Date: May 2010
Location: Cabot ,Ar. Wisconsin at heart
Posts: 65
Re: Push start your GZ.

ok, more like put-put for a couple min. doesnt run so good with no juice in her!
magnum44270 is offline  
Reply With Quote
Old 05-21-2010, 10:53 AM   #15
Easy Rider
Senior Member
 
Join Date: May 2007
Location: Champaign, Illinois
Posts: 4,561
Re: Push start your GZ.

Quote:
Originally Posted by magnum44270
ok, more like put-put for a couple min. doesnt run so good with no juice in her!
Indeed. You are lucky. Others have found that even push starting doesn't work if the battery is TOO dead.

If it hasn't been mentioned already in another thread, you now need to hook your battery up to a low capacity charger for a few hours to be sure it is fully charged again. Sometimes the onboard charging system won't fully restore it.
__________________
Loud pipes risk rights!



Login or Register to Remove Ads
Easy Rider is offline  
Reply With Quote
Old 05-21-2010, 03:11 PM   #16
magnum44270
Member
 
Join Date: May 2010
Location: Cabot ,Ar. Wisconsin at heart
Posts: 65
Re: Push start your GZ.

first thing i did when i got home
magnum44270 is offline  
Reply With Quote
Old 02-27-2012, 01:22 AM   #17
ValleySquid
Junior Member
 
Join Date: Feb 2012
Location: Texas
Posts: 19
Re: Push start your GZ.

Well, I had to learn the hard way.. :retard:
-
:popcorn:
One cold south Texas day, while leaving my house on my 2 week old 2006 GZ250 going to the hospital I do rotation hours at, a red light two blocks away from my house stole my thunder. While waiting for the green light, I didn't realize I had it in 2nd Gear and as soon as the green light lit, I jumped on the throttle and the bike stuttered a bit before shutting off for a second.
Mind you, this is all while seven million cars were waiting behind me, and so since the clutch was not entirely released cause I was barely going, I pressed on it again out of habit and since I had momentum the bike started again by itself.
:rawk:
I immediately went for 1st and away I went.. and lucky me, no they didn't run all over me. :whistle:
ValleySquid is offline  
Reply With Quote
Old 03-22-2012, 11:03 PM   #18
Skunkhome
Senior Member
 
Join Date: Mar 2012
Location: Louisiana
Posts: 203
Re: Push start your GZ.

Quote:
Originally Posted by Easy Rider
Quote:
Originally Posted by magnum44270
ok, more like put-put for a couple min. doesnt run so good with no juice in her!
Indeed. You are lucky. Others have found that even push starting doesn't work if the battery is TOO dead.

If it hasn't been mentioned already in another thread, you now need to hook your battery up to a low capacity charger for a few hours to be sure it is fully charged again. Sometimes the onboard charging system won't fully restore it.
So are we saying that the gz250 has a battery ignition? I thought it was powered by a Magnito.
Skunkhome is offline  
Reply With Quote
Old 03-22-2012, 11:38 PM   #19
blaine
Senior Member
 
blaine's Avatar
 
Join Date: Feb 2010
Location: P.E.I. Canada
Posts: 3,784
Re: Push start your GZ.

Battery,alternator,and regulator,(rectifier). :cool:
__________________
If at first you do succeed, try not to look surprised.


blaine is offline  
Reply With Quote
Old 03-22-2012, 11:48 PM   #20
Skunkhome
Senior Member
 
Join Date: Mar 2012
Location: Louisiana
Posts: 203
Re: Push start your GZ.

So she will not run without a battery?
Skunkhome is offline  
Reply With Quote
Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:24 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.