New rider from Mississauga

[Goose51683]

Go out and buy a Dremel with a few heads, that's what I had to start with. I was able to cut off the bars, I can cut my fender with it. buying a couple tools is a much better investment than buying a fender.

Just my opinion

[malomowny]

It's hard to me, cause I haven't got a lot of money.
When I would cut the fender, how I attach it? Or how I "disable" the curves of plastic? I hope that you understand me.

I hope that I would not need a new seat?

And still please give me some websites or shops when I can buy custom fender to my bike

[jonathan180iq]

There are no custom fenders for this bike.

[malomowny]

I understand.

So please tell me - what is the safest, cheapest and fastest way to cut the fender to make it look great? I'd like to cut it a little bit but what with the sharp edges at the end? What with the light and indicators?

Thank you for your answers

[Goose51683]

Malomowny

To e honest your just gonna have to get creative. I would use a dremel with a carbide blade. Cut your shape the. Sand down the rough edges a bit.

As far as lighting goes you can either use the same lights just figure out a way to attach them to the same fender or you can move them where ever you please. The wiring is incredibly simple so the possibilities are limited only by what you want to do.