04-08-2015, 02:21 AM | #1 |
Junior Member
Join Date: Mar 2015
Location: Michigan
Posts: 14
|
maintenance on a bike that has sat in barn for 7 years
I have just recently bought (triad for 15 hr work on her house) a 2008 Suzuki GZ 250 (my first bike) I transfer the title and I am having keys made tomorrow The original owner put 96 miles on it and set it in the barn for seven years what maintenance or concerns should I address before attempting to start it
Login or Register to Remove Ads |
|
04-08-2015, 08:43 AM | #2 |
Senior Member
Join Date: Feb 2010
Location: P.E.I. Canada
Posts: 3,784
|
Welcome.Change oil & filter,Drain fuel & add new fuel & stabilizer.After sitting that long you will need new tires (dry rotted) Change/flush brake fluid,Change brake fluid & lube cables & pivot points.
|
|
04-08-2015, 08:57 AM | #3 |
Senior Member
Join Date: Nov 2008
Location: Tenerife (Spain)
Posts: 3,719
|
After sitting for seven years, looks like you're going to need a new battery. Make sure you charge it at a low rate, overnight, before you use it. Don't use a car battery charger or you'll fry the battery. A battery tender is a good buy with the battery, as it'll charge at the correct rate, and won't let the battery overcharge. ( even if the salesman says you don't need to charge it - charge it - we've learnt from experience that if you don't, then you'll be buying a new battery very shortly)
Also, the carb is the Achilles heel of the GZ, so make sure you add a carb cleaner to the first tankful of petrol, then every 3 or 4 fillups. Also, you may need to buy an aerosol of contact cleaner, and blast it into the safety switches, i.e. red switch, starter button, clutch switch, and sidestand switch.
__________________
By birth an Englishman, by the grace of God a Yorkshireman. Login or Register to Remove Ads |
|
04-08-2015, 02:13 PM | #4 |
Junior Member
Join Date: Mar 2015
Location: Michigan
Posts: 14
|
Thank you both for the help should I be worried about the piston ring being set up
|
|
04-08-2015, 07:41 PM | #6 |
Senior Member
Join Date: Dec 2006
Location: Squamish B.C Canada
Posts: 11,409
|
Before trying to start the bike you should likely pull the plug and add a couple drops of oil to the cylinder. The rings will thank you. You might also jack up the rear tire and try turning the engine over by rotating the wheel in 5th gear. That should help to spread the oil around the cylinder before an actual start up.
Oh, before I forget. While you are doing the fuel system, install an inline fuel filter. |
|
04-08-2015, 08:44 PM | #7 |
Junior Member
Join Date: Mar 2015
Location: Michigan
Posts: 14
|
Thank you to everyone should be starting it tomorrow had to order the oil filter
|
|
04-08-2015, 09:25 PM | #8 |
Senior Member
Join Date: Sep 2013
Location: Santa Maria, California
Posts: 234
|
Check the fuel lines. After sitting for seven yrs., they might be cracked. Lube anything that moves.
|
|
04-09-2015, 01:29 AM | #9 |
Junior Member
Join Date: Mar 2015
Location: Michigan
Posts: 14
|
Gas lines and hoses look good but there are cracks in the dust boots on the forks
|
|
04-09-2015, 03:26 PM | #10 |
Senior Member
Join Date: Feb 2010
Location: P.E.I. Canada
Posts: 3,784
|
That won't hurt unless the forks start leaking.Than you can replace them with the seals.
|
|
Thread Tools | |
Display Modes | |
|
|