Rejected inspection: front turn signals

[mole2]

Originally Posted by bwader

Ok so I took off the gas tank and was able to see more gang connectors and unhooked and rehooked them in looking in them.

I found a connection on the top frame with a gang connector. When its hooked together I have my problem but when I unhook it the turn signals flash front and back the way they should.

Except that that the headlight and signal lights aren't all on. Just signals work.

Reconnected everything works but my problem with the signals both flashing.

The rear signal lights make the rear brake light flash alternating with whichever signal is chosen.

Those rear bulbs were both 12volt 21watt bulbs. One on the right had "Lo" on it and the other one I can't remember but it was different.

When I test the grounds on the right and left side going to the rear under the seat it is not .1 omms.

Just to be clear, when I test the ground wires I should have it on omms 200 on the meter and pos to the ground wire and neg. to the frame. If its .1 then the ground is good right?

If I remember correctly the bulbs should have only one contact on the bottom. Look at the bulbs and see if someone forced a bulb with two contacts into the socket or visa versa. You'll know how many contacts are required by looking in the socket.