Controls, switches & master cylinder replacement

Boon13 · 12-03-2011, 07:34 PM

I have a GN250 which I'm cleaning up and really want to tidy up the controls. I was thinking about replacing the controls, switches and master cylinder with new OEM TU250 parts. Will this work?

**jonathan180iq** · 12-05-2011, 09:15 AM

You would have to cross reference part numbers to know for sure.

http://www.ronayers.com/Fiche/TypeID/26 ... ake/Suzuki

These bikes are so similar, I don't see why not. But before you go ordering lots of parts, I would double check part numbers and the parts diagrams.

Gz Rider · 12-05-2011, 10:22 AM

...

Water Warrior 2 · 12-05-2011, 02:14 PM

I would have to say GZ parts would be cheaper. You have a better chance of finding the parts and maybe getting some old stock at a reduction. That said, there is usually no old stock and most parts have to be ordered.

12-03-2011, 07:34 PM	#1
Boon13 Junior Member Join Date: Oct 2011 Location: Australia Posts: 5	Controls, switches & master cylinder replacement I have a GN250 which I'm cleaning up and really want to tidy up the controls. I was thinking about replacing the controls, switches and master cylinder with new OEM TU250 parts. Will this work? Login or Register to Remove Ads
	0

12-05-2011, 09:15 AM	#2
jonathan180iq Super Moderator Join Date: Jan 2007 Location: Dalton, GA Posts: 3,996	Re: Controls, switches & master cylinder replacement You would have to cross reference part numbers to know for sure. http://www.ronayers.com/Fiche/TypeID/26 ... ake/Suzuki These bikes are so similar, I don't see why not. But before you go ordering lots of parts, I would double check part numbers and the parts diagrams.
	0

12-05-2011, 10:22 AM	#3
Gz Rider Senior Member Join Date: Aug 2011 Posts: 852	Re: Controls, switches & master cylinder replacement ... __________________ *Alert - This person is a douche. Use these comments and advice at your own risk* Login or Register to Remove Ads
	0

12-05-2011, 02:14 PM	#4
Water Warrior 2 Senior Member Join Date: Dec 2006 Location: Squamish B.C Canada Posts: 11,409	Re: Controls, switches & master cylinder replacement I would have to say GZ parts would be cheaper. You have a better chance of finding the parts and maybe getting some old stock at a reduction. That said, there is usually no old stock and most parts have to be ordered.
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode