Go Back   GZ 250 Forums > GZ250-Specific > Troubleshooting

Reply
 
Thread Tools Display Modes
Old 11-16-2010, 11:47 AM   #11
Canuck
Senior Member
 
Join Date: Aug 2008
Location: Vancouver Island
Posts: 159
Re: Exhaust

I used a Lucas Semi Synthetic 10 w 40 .......


http://www.lucasoil.com/products/displa ... 6&loc=show



Login or Register to Remove Ads
Canuck is offline  
Reply With Quote
Old 11-16-2010, 11:50 AM   #12
Canuck
Senior Member
 
Join Date: Aug 2008
Location: Vancouver Island
Posts: 159
Re: Exhaust

http://www.lucasoil.com/products/displa ... 6&loc=show

Lucas 10w40 Semi Synthetic Motorcycle Oil for wet clutch applications.
Canuck is offline  
Reply With Quote
Old 11-16-2010, 11:59 AM   #13
Canuck
Senior Member
 
Join Date: Aug 2008
Location: Vancouver Island
Posts: 159
Re: Exhaust

Clutch hasn't slipped since the other night... I have adjusted my clutch to be a tad looser than it was

im going ahead with the manifold clamp replacement... custom pipe weld ... seal it off.

My idle and ...starting off in 1st sounds weird. .... it should be perfect considering my Valves are within range.

startin goff sounds abit like "snap crackle and pop" then gradually fades as the bike gets about 20- 30 kms... (switching to second gear)

I also noticed when putting my hand close to the break at the pipe clamp while turning the throttle in Neutral the air can be felt more at a lower twisting of the throttle.. once i get to 1/2 throttle or more its like the force is decreasing the amount of air escaping.

if that makes sense?

more air escaping at lower 1/8 throttle as compared to 1/4-1/2 throttle where i cant feel an increase in air escaping.


Either way .. .I have a visibly corroded clamp on the left pipe ... cant be good for anyone. So ill pay the guy 100 bucks to cut the cancer out and weld in a new pipe . cant hurt i hope!

wish me luck



Login or Register to Remove Ads
Canuck is offline  
Reply With Quote
Old 11-16-2010, 05:23 PM   #14
blaine
Senior Member
 
blaine's Avatar
 
Join Date: Feb 2010
Location: P.E.I. Canada
Posts: 3,784
Re: Exhaust

I think your bike will idle and sound better once you get your exhaust leak fixed. :2tup: :rawk:
__________________
If at first you do succeed, try not to look surprised.


blaine is offline  
Reply With Quote
Old 11-16-2010, 06:35 PM   #15
Viirin
Senior Member
 
Join Date: Aug 2009
Location: Dublin, Ireland
Posts: 269
Re: Exhaust

Wait doesn't the exhaust always have a break in it? i mean near where little condensation hole is? I thought the exhaust was in two parts

....i get backfire when decelerating too



Login or Register to Remove Ads
Viirin is offline  
Reply With Quote
Old 11-16-2010, 07:34 PM   #16
Water Warrior 2
Senior Member
 
Join Date: Dec 2006
Location: Squamish B.C Canada
Posts: 11,409
Re: Exhaust

Quote:
Originally Posted by Canuck

more air escaping at lower 1/8 throttle as compared to 1/4-1/2 throttle where i cant feel an increase in air escaping.

That is a good example of the scavaging affect of the exhaust system.
Water Warrior 2 is offline  
Reply With Quote
Old 11-16-2010, 08:45 PM   #17
blaine
Senior Member
 
blaine's Avatar
 
Join Date: Feb 2010
Location: P.E.I. Canada
Posts: 3,784
Re: Exhaust

Quote:
Originally Posted by Viirin
Wait doesn't the exhaust always have a break in it? i mean near where little condensation hole is? I thought the exhaust was in two parts

....i get backfire when decelerating too
The exhaust is in two pieces.He is talking about the exhaust leaking were it joins under the engine,because it is rusted out.If your exhaust is not leaking,backfiring can be caused by a lean mixture.The odd pop on deceleration is no cause for concern.
:roll: .
__________________
If at first you do succeed, try not to look surprised.


blaine is offline  
Reply With Quote
Old 11-16-2010, 08:53 PM   #18
Viirin
Senior Member
 
Join Date: Aug 2009
Location: Dublin, Ireland
Posts: 269
Re: Exhaust

Cheers Blaine
Viirin is offline  
Reply With Quote
Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:58 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.