changing master cylinder cover - Page 2

dannylightning · 09-18-2009, 12:26 AM

Quote:

Originally Posted by alantf

Quote:

Originally Posted by Water Warrior

Looks good. As long as it seals properly to keep out contaminants you are golden.

Rubber gasket?

no gasket at all, the origional did not have one either, there was a little plastic box in there you had to pop the lid off the box to get to the fluid. so i guess that is the seal.

Water Warrior 2 · 09-18-2009, 01:11 AM

A sealed box inside a box. That would work.

09-18-2009, 01:11 AM	#12
Water Warrior 2 Senior Member Join Date: Dec 2006 Location: Squamish B.C Canada Posts: 11,409	Re: changing master cylinder cover A sealed box inside a box. That would work.
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode