Go Back   GZ 250 Forums > GZ250-Specific > Troubleshooting

Reply
 
Thread Tools Display Modes
Old 10-16-2008, 09:52 PM   #1
jljowers
Junior Member
 
Join Date: Jun 2007
Location: Valdosta, Georgia
Posts: 22
Starting Problems

I am the proud owner of a 2002 GZ250 w/ 7500 miles. Recently, my bike has had problems starting. I turn the key, the engine attempts to start, but does not fire. I checked the oil and it was virtually empty. I have not noticed a leak at all. In fact, the bike is parked in the same place at home and at work. I have not noticed any type of leakage in my garage. Needless to say, I did an oil change and replaced the filter. Still nothing. I have not changed the spark plug yet, but I will tomorrow. Any thoughts on what I should do next? I ride this bike everyday; 30 miles round-trip Monday-Saturday. I have noticed a "gas" smell since the bike has not cranked. I simply do not know what to do next. Any suggestions that you guys could give would be greatly appreciated. Thanks a lot.



Login or Register to Remove Ads
jljowers is offline  
Reply With Quote
Old 10-16-2008, 11:03 PM   #2
patrick_777
Senior Member
 
Join Date: May 2008
Location: Tulsa, OK
Posts: 1,763
Send a message via ICQ to patrick_777 Send a message via AIM to patrick_777 Send a message via Yahoo to patrick_777
Re: Starting Problems

A few little things:
How are you going about checking the oil?
Have you checked to see what your fuel petcock is set to?
Have you checked the tightness of fuel and vacuum lines?
Do you have an inline fuel filter?
__________________
]I am hiding in Honduras. I am a desperate man. Send lawyers, guns and money. The shit has hit the fan.
patrick_777 is offline  
Reply With Quote
Old 10-17-2008, 01:59 AM   #3
jonathan180iq
Super Moderator
 
jonathan180iq's Avatar
 
Join Date: Jan 2007
Location: Dalton, GA
Posts: 3,996
Re: Starting Problems

IS the starter turning over but the bike just won't start? If that's the case, and given your smelling of gas, I'd say you're flooded.

Hold the starter down for a good 15-20 seconds. Turn the key off. Get off the bike. Do 5 jumping jacks and then try to start it again.

Also, take out your air filter and give it a good shaking off.

That'll probably do it.



Login or Register to Remove Ads
jonathan180iq is offline  
Reply With Quote
Old 10-17-2008, 07:22 AM   #4
jljowers
Junior Member
 
Join Date: Jun 2007
Location: Valdosta, Georgia
Posts: 22
Re: Starting Problems

Thanks guys. I'll give it a try and repost.
jljowers is offline  
Reply With Quote
Old 10-18-2008, 04:55 PM   #5
jljowers
Junior Member
 
Join Date: Jun 2007
Location: Valdosta, Georgia
Posts: 22
Re: Starting Problems

I took the air filter out and blew it off. It was practically clean. I changed the spark plug. I made sure that my battery was fully charged. And still, I press the ignition and the engine just turns over. Any thoughts? THanks for being patient with newbies.



Login or Register to Remove Ads
jljowers is offline  
Reply With Quote
Old 10-20-2008, 06:10 AM   #6
Badbob
Senior Member
 
Badbob's Avatar
 
Join Date: Aug 2006
Location: Tallahassee FL
Posts: 945
Re: Starting Problems

Do you have a spark? No spark, no start.

If the starter is spinning all of the interlock switches are working.
Badbob is offline  
Reply With Quote
Old 10-21-2008, 01:30 AM   #7
mr. softie
Senior Member
 
Join Date: Jun 2008
Location: Bucks Co. PA
Posts: 361
Re: Starting Problems

Really check that the vacuum hose to the petcock is connected at both ends and is in good shape as Patrick_77 said. I had to cut a bit off both ends of mine to get a tight fit. No fuel will pass if not enough/no vacuum is present at petcock. The fuel line can also be bad-swollen shut inside. If you have spark and fuel it should start.
__________________
The real money in a gold rush is in supplying liqueur and women to the miners....
May the wind always be at your back and the sun overhead as you make your way down the ever winding, smoothly paved, traffic free road!
mr. softie is offline  
Reply With Quote
Old 10-21-2008, 08:11 PM   #8
Easy Rider
Senior Member
 
Join Date: May 2007
Location: Champaign, Illinois
Posts: 4,561
Re: Starting Problems

Quote:
Originally Posted by mr. softie
No fuel will pass if not enough/no vacuum is present at petcock.
Unless it is set to PRIme, which defeats the vacuum shut-off feature.
__________________
Loud pipes risk rights!
Easy Rider is offline  
Reply With Quote
Old 10-22-2008, 11:16 PM   #9
mr. softie
Senior Member
 
Join Date: Jun 2008
Location: Bucks Co. PA
Posts: 361
Re: Starting Problems

Easy, you are absolutely correct sir! :plus1:
__________________
The real money in a gold rush is in supplying liqueur and women to the miners....
May the wind always be at your back and the sun overhead as you make your way down the ever winding, smoothly paved, traffic free road!
mr. softie is offline  
Reply With Quote
Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:20 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.