![]() |
#11 |
Junior Member
Join Date: Nov 2012
Location: alabama
Posts: 15
|
Re: Bike wont start after changing the Generator cover..
Thanks alan, I charged it overnight on 2A and it did nothing this morning. Noticed the charging recommendations on the battery this morning finally.. Definitely need a different charger lol. Brought the battery to be tested and its bad :/. BUT when I loosened the bolts to take the cover off I tried it and it turned over.. I'm thinking my homemade gasket job came out too thin and the cover is putting the starter idle gear in a bind. I notice there isn't much room at the end of the pin it slides on and both the gear and the hole in the cover for the pin are fluch with thebedge of the cover/motor.. any of this make any sense to anybody? Lol
Login or Register to Remove Ads |
![]() |
![]() |
|
|