Register Community Calendar Today's Posts Search

Go Back   GZ 250 Forums > GZ250-Specific > Instructional Articles

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 10-04-2011, 02:17 PM   #1
jonathan180iq
Super Moderator
 
jonathan180iq's Avatar
 
Join Date: Jan 2007
Location: Dalton, GA
Posts: 3,996
How-to : Valve Adjustment

The following "How-to" as been adapted for this forum from: http://i2kdave.wordpress.com/2009/07/23 ... djustment/
All credit should be given to the original poster, i2kDave and board member Brucea for finding it.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~~~~~~~~~

Here are the tools you will need:
6mm allen wrench
flat wrench, or other similar tool
3? extension (optional)
ratchet
set of feeler gauges
8mm wrench
22mm socket
17mm socket
10mm socket
valve adjuster tool (09917-14920)
spark plug wrench




First, remove the two 10mm bolts holding the back of the gas tank.




Make sure the fuel valve is in either the “ON” or “RES” position, and disconnect the fuel hose and vacuum hose. Now you can lift the gas tank off and sit it aside.




Remove the left cylinder head cover cap with the 6mm allen wrench.




Disconnect the spark plug and remove it with the spark plug wrench.




Remove the four 10mm bolts indicated by the arrows to remove the valve inspection caps.




Next, you need to get the piston in the correct position before checking the valves. Remove the valve timing inspection plug with the 17mm socket, and the generator cover cap.




I had to loosen the cap with some WD-40 and removed it with a flat wrench I had in my toolbox.




Using the 22mm socket, turn the crankshaft until the “T” mark aligns with the arrow on the generator cover, and the piston is on the compression stroke. You can tell when it’s there by plugging the spark plug hole with your finger and rotating the crankshaft until you feel pressure on your finger.




Once all that is done, you can start checking the valve clearances. You’ll be checking the space between the valve stem and the adjusting screw, indicated by the arrow. Be aware, the intake and exhaust valves have different specs. Just to clarify, the intake is toward the rear of the bike, and the exhaust is toward the front.




If any need adjusting, loosen the locknut with the 8mm wrench and turn the adjusting screw with the valve adjuster tool until it has the proper clearance. Try not to let the screw turn while you’re tightening down the locknut, or you’ll have to adjust it again. Trust me, I speak from experience.

The exhaust side isn’t that difficult to work with, but the intake is in a very tight location. I moved some of the wires and cables out of the way and still had a hard time getting my fingers in there. Do yourself a favor and buy some angled feeler gauges. Mine are flat, and that made it even more difficult, not to mention that they got all bent up in the process.

Once you get them all adjusted to spec and the locknuts tightened down, rotate the crankshaft 720° and check the clearances again. If everything is good to go, just put everything back together and you’re done!



Login or Register to Remove Ads
jonathan180iq is offline  
Reply With Quote
 




Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:23 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.