I heard marbles rattling in the engine and it just stopped.

dannylightning · 04-27-2010, 11:26 AM

a breaker bar to get the axel bolt loose, the torque on the rear axel is only supposed to be tightened to something like 50lbs of torque unless it is rusty or corroded it should be easy to get off. don't remember exactly the amount of torque needed so do not go by what i have just said, but i'm pretty sure it was 50 some lbs. i used a torque wrench i got at auto zone to tighten it up, i may have used it to get the wheel off too, cant remember but it cost about 10 dollars. make sure you put in a new cotter pin after removing the old one.

04-27-2010, 11:26 AM	#18
dannylightning Senior Member Join Date: Apr 2009 Location: akron ohio Posts: 893	Re: I heard marbles rattling in the engine and it just stopp a breaker bar to get the axel bolt loose, the torque on the rear axel is only supposed to be tightened to something like 50lbs of torque unless it is rusty or corroded it should be easy to get off. don't remember exactly the amount of torque needed so do not go by what i have just said, but i'm pretty sure it was 50 some lbs. i used a torque wrench i got at auto zone to tighten it up, i may have used it to get the wheel off too, cant remember but it cost about 10 dollars. make sure you put in a new cotter pin after removing the old one.
	0