Just came back from my first ride after "needle shim mod"

[David Bo]

Thanks Blackbird... I just have to find a muffler shop that can weld it for me. I have access to a welder but it is a "stick" welder, not a mig welder. I believe stick welders will get too hot and burn throught the chrome. Did your EMGO come with a clamp?

I am wondering if I could use some of that JB Weld stuff where you mix the A tube and the B tube and then set the pipes in place (maybe with a clamp on top of the seam). The website says it works with temperatures up to 500 degrees F.

Does anyone have any thoughts on this???