Go Back   GZ 250 Forums > GZ250-Specific > Troubleshooting

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 02-25-2017, 06:20 PM   #1
Mrkai
Junior Member
 
Join Date: Feb 2017
Posts: 11
Won't start up. Power issue

So a few weeks ago I had to replace my right rear blinker. I changed it and then the switch wasn't really working well so I started poking around with a multi meter. I may have shorted something but I'm not sure. Anyway, I had a bad battery, went to autozone got a new one and it was bad. Swapped it for a somewhat working one and it turns over but only one turn before it starts clicking. It's a 2008. Only mod is the running tail light. I have it hooked up to the ground on battery and one of the orange cables on the bottom of the Fuze box. Today I pulled the bike apart looking for a hot wire. I hooked up the voltmeter to the ground on battery and the ground wire that goes to the battery. It was reading around 11volts. The battery is probably bad by now. I have been push starting the bike for a few weeks. When the bike is running the battery reads around 14.5 volts. Anyhow, I was looking for a hot wire and I found that the red wire running from the Starter Relay when unplugged would make the voltage reading go away. Also when everything was hooked up I disconnected the regulator/rectifier red cable hookup and the volt reading went away again. Any help would be greatly appreciated. I still have warranty on battery. Any suggestions on good battery's for these bikes? Autozone battery's suck. It's a gold duralast

Sent from my SM-G930V using Tapatalk



Login or Register to Remove Ads
Mrkai is offline  
Reply With Quote
 



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:33 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.