Warmed up but won't start?

mainlinecoffee · 03-10-2014, 02:48 AM

It is disabled but it may cause problems. I couldn't find my soldering iron so I stripped the wires and tied them in a double knot before sealing them with liquid electrical tape. When I work on the bike tomorrow I will double check that everything is in order with the clutch and the kickstand. I still do not understand that diagram but I will go on a bit of faith and check it all out. I am still absolutely puzzled by the tail light though. Is it possible it was a bad ground?

03-10-2014, 02:48 AM	#21
mainlinecoffee Senior Member Join Date: Oct 2013 Location: lexington ky Posts: 223	It is disabled but it may cause problems. I couldn't find my soldering iron so I stripped the wires and tied them in a double knot before sealing them with liquid electrical tape. When I work on the bike tomorrow I will double check that everything is in order with the clutch and the kickstand. I still do not understand that diagram but I will go on a bit of faith and check it all out. I am still absolutely puzzled by the tail light though. Is it possible it was a bad ground? Login or Register to Remove Ads
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode