Failed Emissions test- CO was too high. What now?

Fausto · 09-24-2012, 10:15 AM

Hey folks, here is an update.
I replaced the vacume hose and tiny clamps. Installed inline filter. Sprayed hoses with WD-40 while running and noticed no difference in sound. While the GZ was running I switched the petcock to run and a few min later it turned off and I noticed the fuel filter was dry.
I found the other vacume hose that runs down from the air box. Should that have a cap at the end? Cause it does.
I dont know what to do next. Is it my petcock that is bad?

09-24-2012, 10:15 AM	#21
Fausto Junior Member Join Date: Jun 2012 Location: Tempe, AZ Posts: 19	Re: Failed Emissions test- CO was too high. What now? Hey folks, here is an update. I replaced the vacume hose and tiny clamps. Installed inline filter. Sprayed hoses with WD-40 while running and noticed no difference in sound. While the GZ was running I switched the petcock to run and a few min later it turned off and I noticed the fuel filter was dry. I found the other vacume hose that runs down from the air box. Should that have a cap at the end? Cause it does. I dont know what to do next. Is it my petcock that is bad? Login or Register to Remove Ads
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode