Seafoam in engine oil?

minieggroll · 03-10-2012, 01:28 PM

Just tried this method described by DBG. Pulled spark plug, sprayed Deep Creep (seafoam) into the spark plug hole for about 10-20 seconds.

Shifted to second gear and pushed the bike around to make sure the deep creep is spread out by moving the cylinder head. Then waited 30 minutes and put everything back together.

When I turned the bike on, it had trouble starting for about 10 seconds, then started right up and smoked like hell, rode her around for a while. Seems to run better.

Does anyone know if the deep creep gets burnt or goes into your engine oil? How much deep creep should I use next time? I'm just worried about it increasing my engine oil levels.

03-10-2012, 01:28 PM	#31
minieggroll Member Join Date: Feb 2012 Location: Columbus Ohio Posts: 73	Re: Seafoam in engine oil? Just tried this method described by DBG. Pulled spark plug, sprayed Deep Creep (seafoam) into the spark plug hole for about 10-20 seconds. Shifted to second gear and pushed the bike around to make sure the deep creep is spread out by moving the cylinder head. Then waited 30 minutes and put everything back together. When I turned the bike on, it had trouble starting for about 10 seconds, then started right up and smoked like hell, rode her around for a while. Seems to run better. Does anyone know if the deep creep gets burnt or goes into your engine oil? How much deep creep should I use next time? I'm just worried about it increasing my engine oil levels. Login or Register to Remove Ads
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode