Fuel not going into the carburetor

Gustaf · 08-13-2011, 10:20 PM

I can only get my GZ250 started if I put the fuel switch into PRI position for at least 5 seconds.

Then it runs for a couple of minutes, starts sputtering, and stops. It will not get started unless I put it into PRI again.

My motorcycle has been in storage for a while, but I was able to get it started without any problems a couple of months ago.

I added new fuel, the engine sounds better now, but the problem persists.

Any suggestions will be much appreciated.

Thank you,
Gustaf

08-13-2011, 10:20 PM	#1
Gustaf Junior Member Join Date: Aug 2011 Location: Ottawa Posts: 3	Fuel not going into the carburetor I can only get my GZ250 started if I put the fuel switch into PRI position for at least 5 seconds. Then it runs for a couple of minutes, starts sputtering, and stops. It will not get started unless I put it into PRI again. My motorcycle has been in storage for a while, but I was able to get it started without any problems a couple of months ago. I added new fuel, the engine sounds better now, but the problem persists. Any suggestions will be much appreciated. Thank you, Gustaf Login or Register to Remove Ads
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode