Release arm on camshaft

Vansky · 06-27-2011, 11:30 AM

Hey all,

I recently replaced a leaking oil seal on my camshaft. However, when putting back on the release arm (in what I thought was the correct position as I took a picture before i took it off) I notice when squeezing the clutch lever there is no tension it just hangs completely loose.

Can anyone give me some advise on how to correct this? Thanks.

06-27-2011, 11:30 AM	#1
Vansky Member Join Date: Jun 2010 Location: Myrtle Beach, SC Posts: 52	Release arm on camshaft Hey all, I recently replaced a leaking oil seal on my camshaft. However, when putting back on the release arm (in what I thought was the correct position as I took a picture before i took it off) I notice when squeezing the clutch lever there is no tension it just hangs completely loose. Can anyone give me some advise on how to correct this? Thanks. Login or Register to Remove Ads
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode