internal carburator part question

DAN · 03-19-2011, 05:43 PM

Inside the GZ mikuni carb lower body, I am following the disasembly instructions in the manual getting it stripped for a chemical bath. Under the starter jet marked #16 in the manual, there is a brass insert like a jet or a tube, very tiny hole, that has no removal insruction. This insert also has a air hole (in the aluminium body) at the base near the roof of the inside of the lower carb main body (upper opposit end than the lower end the starter jet screws into. Question; does this brass piece come out of the body, is it permanently pressed in or does it have orings that might be damaged by a chemical bath?? --Dan--

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

03-19-2011, 05:43 PM	#1
DAN Junior Member Join Date: Apr 2007 Location: Fort Lauderdale Posts: 25	internal carburator part question Inside the GZ mikuni carb lower body, I am following the disasembly instructions in the manual getting it stripped for a chemical bath. Under the starter jet marked #16 in the manual, there is a brass insert like a jet or a tube, very tiny hole, that has no removal insruction. This insert also has a air hole (in the aluminium body) at the base near the roof of the inside of the lower carb main body (upper opposit end than the lower end the starter jet screws into. Question; does this brass piece come out of the body, is it permanently pressed in or does it have orings that might be damaged by a chemical bath?? --Dan-- __________________ 1999 GZ250 - teal green past bikes 100cc twin yamaha-1960's era - first bike 100cc and 125cc honda CB 350cc yamaha twin - 1970 160cc honda -1966 model 350cc honda CB 1970 350cc honda SL 650 Yamaha 1972 F650gs BMW 2007 Virago 750 Yamaha 1996 Login or Register to Remove Ads
	0