Just a few questions....

GZ Jess · 06-11-2010, 11:30 AM

Well I finally got to the plug, not a bad job at all. When I started to work at getting the wire off (black cap thing) I noticed that the plug was so loose it wiggled in the block. I got it completely out using my fingers only. As you can see by the attached pic the plug is not discolored or overly corroded. I don't have a gapper so I am just going to put it back in and tighten it correctly. I will go for a short ride, hopefully a tag, and see if anything has changed. I think I will pick up a new plug and gapper when my new air filter comes in (had to order) and replace it soon after. Thanks everyone and I will report back shortly!

Jessica

06-11-2010, 11:30 AM	#34
GZ Jess Senior Member Join Date: May 2010 Location: NE Ohio Posts: 100	Re: Just a few questions.... Well I finally got to the plug, not a bad job at all. When I started to work at getting the wire off (black cap thing) I noticed that the plug was so loose it wiggled in the block. I got it completely out using my fingers only. As you can see by the attached pic the plug is not discolored or overly corroded. I don't have a gapper so I am just going to put it back in and tighten it correctly. I will go for a short ride, hopefully a tag, and see if anything has changed. I think I will pick up a new plug and gapper when my new air filter comes in (had to order) and replace it soon after. Thanks everyone and I will report back shortly! Jessica
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode