Proper Use of Prime

RWBitters · 03-15-2010, 05:42 PM

I hope this is not a repeat question, I Looked for an old post on this topic, but haven't found one.

Got a gz250 last summer. So last fall I put stabil in the tank, ran the bike a bit, topped off the tank, and drained the floatbowl on the carb.

It's now March and some nice weather is predicted for this weekend. So my question is how do I use the Prime setting to properly restart the bike? How long do I leave it on the prime setting? Do I switch it to Run before I try to start the bike, or after?

Geo

03-15-2010, 05:42 PM	#1
RWBitters Junior Member Join Date: Jun 2009 Location: Exton, PA Posts: 7	Proper Use of Prime I hope this is not a repeat question, I Looked for an old post on this topic, but haven't found one. Got a gz250 last summer. So last fall I put stabil in the tank, ran the bike a bit, topped off the tank, and drained the floatbowl on the carb. It's now March and some nice weather is predicted for this weekend. So my question is how do I use the Prime setting to properly restart the bike? How long do I leave it on the prime setting? Do I switch it to Run before I try to start the bike, or after? Geo Login or Register to Remove Ads
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode