Head gasket replacement?

Quimrider · 10-15-2008, 11:17 AM

Ok so maybe I exaggerated a bit

I do about 2/3 highway 1/3 city. 95% of my riding is 45mph + However, unless the wind is at my back 65-70mph is usually WOT with the taller 16t sprocket. Which of course isn't quite as hard on the engine as WOT at 75mph+ with the stock 15t sprocket.

I'm quite perplexed about the leaky valve cover. Maybe the 7ft-lb torque spec in the service manual is wrong? That doesn't seem very tight for a part of the engine that receives quite a bit of vibration. I hope it's not the case but I suppose it's possible my cylinder head is warped. Awe screw it!!! I'll just throw on that big bore kit and be done with it! :lol:

10-15-2008, 11:17 AM	#11
Quimrider Senior Member Join Date: Jun 2007 Location: Toledo, OH Posts: 198	Re: Head gasket replacement? Ok so maybe I exaggerated a bit I do about 2/3 highway 1/3 city. 95% of my riding is 45mph + However, unless the wind is at my back 65-70mph is usually WOT with the taller 16t sprocket. Which of course isn't quite as hard on the engine as WOT at 75mph+ with the stock 15t sprocket. I'm quite perplexed about the leaky valve cover. Maybe the 7ft-lb torque spec in the service manual is wrong? That doesn't seem very tight for a part of the engine that receives quite a bit of vibration. I hope it's not the case but I suppose it's possible my cylinder head is warped. Awe screw it!!! I'll just throw on that big bore kit and be done with it! :lol: Login or Register to Remove Ads
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode