10-16-2010, 08:43 PM | #21 |
Junior Member
Join Date: Sep 2010
Location: western nc
Posts: 4
|
Re: Speedo Light Out.
I am really new here but...will chime in...have built two street rods from the ground up...looks like it would be easier to to take the top headlight bolt out and loosen the bottom bolt and then tilt the headlight down...then you have good access to the speedometer....and much easier to change the bulb...mine is out also...so will be doing this in a week or so...
Jimmy in NC Login or Register to Remove Ads |
|
10-16-2010, 10:26 PM | #22 | |
Senior Member
Join Date: Apr 2010
Location: Lubbock, TX
Posts: 629
|
Re: Speedo Light Out.
Quote:
__________________
2007 Shadow Spirit 750 |
|
|
10-16-2010, 10:46 PM | #23 | ||
Senior Member
Join Date: Feb 2010
Location: P.E.I. Canada
Posts: 3,784
|
Re: Speedo Light Out.
Quote:
Login or Register to Remove Ads |
||
|
10-21-2010, 03:34 AM | #24 |
Senior Member
Join Date: Apr 2010
Location: Florida
Posts: 142
|
Re: Speedo Light Out.
My bulb went out as well and have not had time to replace it.....What I did was get some glow in the dark paint and marked long lines at the 10s and short lines at the 5s. I don't ride much after dusk and more often than not this little trick does the job...
When I get around to replacing the bulb I'll just remove the paint... chandlerbingfl |
|
10-23-2010, 03:37 AM | #25 |
Senior Member
Join Date: Mar 2010
Location: ray city, ga
Posts: 121
|
Re: Speedo Light Out.
i dont think the LEDs were that much brighter than standard bulbs on my ZX-7, but the amber is FAR easier to read. in my experience, red looks nice, but isnt always as easy to read at a glance. less of an issue with the GZ since there isnt much in the way of lighting. only one gage with a sweep needle. another reason i stay away from red gage lighting is so i can immediately recognize an idiot light if it comes on and it not blend in.
for constant lighting such as a non-flashing marker light or backlighting for an instrument... if the bulb is a 194 and you replace it with a LED 194, no modification is needed at all. if you replace your turn signals, the resistance is different and will cause a super-rapid flash signal and you'd have to install an inline resistor to level that out. Login or Register to Remove Ads |
|
10-23-2010, 08:55 PM | #26 | |
Senior Member
Join Date: Dec 2006
Location: Squamish B.C Canada
Posts: 11,409
|
Re: Speedo Light Out.
Quote:
|
|
|
|
|