Upgrade carb to PWK28

[Onski316]

I fought with the stupid Mikuni long enough. Even tried a couple others and was NOT happy with how they ran. Very sluggish and wheezy on the top end. So I went off-script and bought a PWK28 off Amazon and installed. Both ends are just a few mm smaller so the fit pretty well and clamped down nicely. It does seem to be a little shorter so I had to take the air box loose to get it to fit tight. I just put a block between it and the toolbox tray to keep it supported. Needed a new throttle cable as the ends on the OEM one were not good. But any generic dirt bike 250 throttle cable works. Sooooo much better! Throttle response is amazingly more crisp and pulls much harder. Best mod yet!