Carb problem,no acceleration

Wildcat700 · 05-08-2018, 06:36 PM

Gz250 will idle all day long, give it throttle it will cut out, not quite though. Have torn it apart 3-4 times put it in carb cleaner, all ports seem to be open. Definitely carb problem, took neighbors carb off of his bike and runs great. Put choke on and you can get slightly higher rpm before it cuts out. Any help would be appreciated!

derbydave · 05-09-2018, 06:38 PM

did you clean and service the idle circuit and o-ring under the brass plug on the bottom? Even if it seems to idle ok that circuit can cause problems when the throttle plate is opened.

You might also look at this thread. http://www.gz250bike.com/forum/showthread.php?t=8075

Wildcat700 · 05-09-2018, 11:01 PM

Yes I did but I read the link you sent, I will definitely check that out, thanks

Sent from my XT1585 using Tapatalk

05-08-2018, 06:36 PM	#1
Wildcat700 Junior Member Join Date: May 2018 Posts: 2	Carb problem,no acceleration Gz250 will idle all day long, give it throttle it will cut out, not quite though. Have torn it apart 3-4 times put it in carb cleaner, all ports seem to be open. Definitely carb problem, took neighbors carb off of his bike and runs great. Put choke on and you can get slightly higher rpm before it cuts out. Any help would be appreciated! Login or Register to Remove Ads
	0

05-09-2018, 06:38 PM	#2
derbydave Senior Member Join Date: Jan 2017 Location: KS Posts: 103	did you clean and service the idle circuit and o-ring under the brass plug on the bottom? Even if it seems to idle ok that circuit can cause problems when the throttle plate is opened. You might also look at this thread. http://www.gz250bike.com/forum/showthread.php?t=8075 __________________ 2003 Suzuki GZ250 (Sold) 1986 Suzuki Cavalcade LXE 1986 Suzuki Intruder VS700
	1

05-09-2018, 11:01 PM	#3
Wildcat700 Junior Member Join Date: May 2018 Posts: 2	Yes I did but I read the link you sent, I will definitely check that out, thanks Sent from my XT1585 using Tapatalk Login or Register to Remove Ads
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode