A couple problems

Nathan · 11-18-2017, 09:16 PM

Back story-
I have a 06 that was a complete basket case. It droped a valve and I now have a 01 parts bike that had a bad bottom end. So now I did a complete rebuild and am about a week out from doing a first fire
Current problems-
How hard is it to change the turn signal switch. Mine is going south and the other bike is perfect.

How do I take apart the headlight. Because my speedometer is pretty bad condition and i want to take it parts bike one.

This is all I can think if at the moment but I will keep an update on what else I need help with.

Water Warrior 2 · 11-19-2017, 05:02 PM

If the signal switch is just sticky you can give it a good shot of contact cleaner and exercise it a bit to see if that makes a difference.

Heli ATP · 11-19-2017, 08:03 PM

Download the service manual on this site for detailed descriptions of the help you need. Good Luck with your project.

11-18-2017, 09:16 PM	#1
Nathan Junior Member Join Date: Oct 2017 Location: Lewisburg PA Posts: 2	A couple problems Back story- I have a 06 that was a complete basket case. It droped a valve and I now have a 01 parts bike that had a bad bottom end. So now I did a complete rebuild and am about a week out from doing a first fire Current problems- How hard is it to change the turn signal switch. Mine is going south and the other bike is perfect. How do I take apart the headlight. Because my speedometer is pretty bad condition and i want to take it parts bike one. This is all I can think if at the moment but I will keep an update on what else I need help with. Login or Register to Remove Ads
	0

11-19-2017, 08:03 PM	#3
Heli ATP Junior Member Join Date: Nov 2015 Location: NE PA, USA Posts: 15	Service Manual Download the service manual on this site for detailed descriptions of the help you need. Good Luck with your project. Login or Register to Remove Ads
	1

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-19-2017, 05:02 PM	#2
Water Warrior 2 Senior Member Join Date: Dec 2006 Location: Squamish B.C Canada Posts: 11,409	If the signal switch is just sticky you can give it a good shot of contact cleaner and exercise it a bit to see if that makes a difference.
	0