Well, she finally puked her guts out.... (pic) - Page 2

derbydave · 03-13-2017, 10:54 AM

So did you figure out where it puked the oil from?

spldart · 03-13-2017, 11:43 AM

head gasket wasnt blown out but it was wet with oil.
didn't find a crack in the head.
cleaned head up pretty good.
Hoping it was just the head gasket.

spldart · 03-13-2017, 11:55 AM

pissed off at mysellf that I didn't get picture of new piston in the new cylinder and I didn't get a pic of the cleaned up head combustion chamber..
But but the new episode of Walking Dead was coming on in an hour!

spldart · 03-13-2017, 12:01 PM

Motor will get it first start on tuesday or wednesday.
Only problem I found with the kit I bought from china was the compression ring for the oil control ring groove. It was buggered slightly in a small area so I had to straiten it a little bit.
Otherwise the kit fit very well.

Water Warrior 2 · 03-13-2017, 12:15 PM

Good to hear things are looking up. It could have been worse.

Vegas Street Rider · 03-13-2017, 01:08 PM

Can't miss the Walking Dead! I'm hooked. Daryl would be proud of you.

spldart · 03-14-2017, 02:31 PM

Started first try.

derbydave · 03-14-2017, 04:27 PM

Are all the strange noises gone

spldart · 03-14-2017, 06:28 PM

Nope.
She failed test drive.
Making what sounds kinda like a light rod knock or broken ring sound.
Noise starts at 2500 rpm and continues up.
However Idle sounds perfect.
Compression good, engine didn't sieze.
Even ran to Orielly's with it rattling away.
I guess I tear it down again tomorrow.

Vegas Street Rider · 03-14-2017, 06:55 PM

Sorry. That just sucks.

03-13-2017, 10:54 AM	#11
derbydave Senior Member Join Date: Jan 2017 Location: KS Posts: 103	So did you figure out where it puked the oil from? __________________ 2003 Suzuki GZ250 (Sold) 1986 Suzuki Cavalcade LXE 1986 Suzuki Intruder VS700 Login or Register to Remove Ads
	0

03-13-2017, 11:55 AM	#13
spldart Senior Member Join Date: May 2015 Location: Stafford, Texas Posts: 604	pissed off at mysellf that I didn't get picture of new piston in the new cylinder and I didn't get a pic of the cleaned up head combustion chamber.. But but the new episode of Walking Dead was coming on in an hour! Login or Register to Remove Ads Last edited by spldart; 03-13-2017 at 11:59 AM.
	0

03-13-2017, 12:15 PM	#15
Water Warrior 2 Senior Member Join Date: Dec 2006 Location: Squamish B.C Canada Posts: 11,409	Good to hear things are looking up. It could have been worse. Login or Register to Remove Ads
	0

03-14-2017, 04:27 PM	#18
derbydave Senior Member Join Date: Jan 2017 Location: KS Posts: 103	Are all the strange noises gone __________________ 2003 Suzuki GZ250 (Sold) 1986 Suzuki Cavalcade LXE 1986 Suzuki Intruder VS700
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

03-13-2017, 11:43 AM	#12
spldart Senior Member Join Date: May 2015 Location: Stafford, Texas Posts: 604	head gasket wasnt blown out but it was wet with oil. didn't find a crack in the head. cleaned head up pretty good. Hoping it was just the head gasket.
	0

03-13-2017, 12:01 PM	#14
spldart Senior Member Join Date: May 2015 Location: Stafford, Texas Posts: 604	Motor will get it first start on tuesday or wednesday. Only problem I found with the kit I bought from china was the compression ring for the oil control ring groove. It was buggered slightly in a small area so I had to straiten it a little bit. Otherwise the kit fit very well.
	0

03-13-2017, 01:08 PM	#16
Vegas Street Rider Senior Member Join Date: May 2015 Location: Henderson, NV Posts: 1,108	Can't miss the Walking Dead! I'm hooked. Daryl would be proud of you.
	0

03-14-2017, 02:31 PM	#17
spldart Senior Member Join Date: May 2015 Location: Stafford, Texas Posts: 604	Started first try.
	0

03-14-2017, 06:28 PM	#19
spldart Senior Member Join Date: May 2015 Location: Stafford, Texas Posts: 604	Nope. She failed test drive. Making what sounds kinda like a light rod knock or broken ring sound. Noise starts at 2500 rpm and continues up. However Idle sounds perfect. Compression good, engine didn't sieze. Even ran to Orielly's with it rattling away. I guess I tear it down again tomorrow.
	0

03-14-2017, 06:55 PM	#20
Vegas Street Rider Senior Member Join Date: May 2015 Location: Henderson, NV Posts: 1,108	Sorry. That just sucks.
	0