oil filter bypass

raunchy57 · 07-30-2015, 09:56 PM

Ok I'm feeling kind of sheepish but I need some help from an expert. I recently obtained a 2000 Gz250 for my daughter. I pulled what I thought was the oil sump drain plug, but when I poured the used oil into a container I found a spring and a plunger. I suspect that this is the oil filter bypass assembly. the plug is located just in front of the actual oil sump plug on the bottom of the engine case. my question is....... what is the proper position to install the plunger, pin side up, or pin inserted into the spring and plunger side up? I have searched through a factory service manual and it doesn't cover the bypass other that it exists

blaine · 07-31-2015, 12:29 AM

It is the plunger to keep you from shifting more than one gear at a time.You are not the first to mistake it for the oil drain.Pin goes up.

raunchy57 · 08-02-2015, 06:18 PM

thank you so much!!, I searched the manual and the web and could not find anything about it

blaine · 08-03-2015, 12:52 AM

#17 to #20.

http://www.ronayersmotorcycles.com/f...008&fveh=18967

raunchy57 · 08-05-2015, 11:02 PM

Cool, Thank you!!.......[url]http://www.manualagent.com/suzuki/gz250/users-manual, I found this one online

08-02-2015, 06:18 PM	#3
raunchy57 Junior Member Join Date: Jul 2015 Posts: 3	thank you so much!!, I searched the manual and the web and could not find anything about it Login or Register to Remove Ads
	0

08-03-2015, 12:52 AM	#4
blaine Senior Member Join Date: Feb 2010 Location: P.E.I. Canada Posts: 3,784	#17 to #20. http://www.ronayersmotorcycles.com/f...008&fveh=18967 __________________ If at first you do succeed, try not to look surprised.
	0

08-05-2015, 11:02 PM	#5
raunchy57 Junior Member Join Date: Jul 2015 Posts: 3	Cool, Thank you!!.......[url]http://www.manualagent.com/suzuki/gz250/users-manual, I found this one online Login or Register to Remove Ads
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-30-2015, 09:56 PM	#1
raunchy57 Junior Member Join Date: Jul 2015 Posts: 3	oil filter bypass Ok I'm feeling kind of sheepish but I need some help from an expert. I recently obtained a 2000 Gz250 for my daughter. I pulled what I thought was the oil sump drain plug, but when I poured the used oil into a container I found a spring and a plunger. I suspect that this is the oil filter bypass assembly. the plug is located just in front of the actual oil sump plug on the bottom of the engine case. my question is....... what is the proper position to install the plunger, pin side up, or pin inserted into the spring and plunger side up? I have searched through a factory service manual and it doesn't cover the bypass other that it exists Login or Register to Remove Ads
	0

07-31-2015, 12:29 AM	#2
blaine Senior Member Join Date: Feb 2010 Location: P.E.I. Canada Posts: 3,784	It is the plunger to keep you from shifting more than one gear at a time.You are not the first to mistake it for the oil drain.Pin goes up. __________________ If at first you do succeed, try not to look surprised.
	0