10-16-2008, 09:52 PM | #1 |
Junior Member
Join Date: Jun 2007
Location: Valdosta, Georgia
Posts: 22
|
Starting Problems
I am the proud owner of a 2002 GZ250 w/ 7500 miles. Recently, my bike has had problems starting. I turn the key, the engine attempts to start, but does not fire. I checked the oil and it was virtually empty. I have not noticed a leak at all. In fact, the bike is parked in the same place at home and at work. I have not noticed any type of leakage in my garage. Needless to say, I did an oil change and replaced the filter. Still nothing. I have not changed the spark plug yet, but I will tomorrow. Any thoughts on what I should do next? I ride this bike everyday; 30 miles round-trip Monday-Saturday. I have noticed a "gas" smell since the bike has not cranked. I simply do not know what to do next. Any suggestions that you guys could give would be greatly appreciated. Thanks a lot.
Login or Register to Remove Ads |
|
10-16-2008, 11:03 PM | #2 |
Senior Member
|
Re: Starting Problems
A few little things:
How are you going about checking the oil? Have you checked to see what your fuel petcock is set to? Have you checked the tightness of fuel and vacuum lines? Do you have an inline fuel filter?
__________________
]I am hiding in Honduras. I am a desperate man. Send lawyers, guns and money. The shit has hit the fan. |
|
10-17-2008, 01:59 AM | #3 |
Super Moderator
Join Date: Jan 2007
Location: Dalton, GA
Posts: 3,996
|
Re: Starting Problems
IS the starter turning over but the bike just won't start? If that's the case, and given your smelling of gas, I'd say you're flooded.
Hold the starter down for a good 15-20 seconds. Turn the key off. Get off the bike. Do 5 jumping jacks and then try to start it again. Also, take out your air filter and give it a good shaking off. That'll probably do it. Login or Register to Remove Ads |
|
10-17-2008, 07:22 AM | #4 |
Junior Member
Join Date: Jun 2007
Location: Valdosta, Georgia
Posts: 22
|
Re: Starting Problems
Thanks guys. I'll give it a try and repost.
|
|
10-18-2008, 04:55 PM | #5 |
Junior Member
Join Date: Jun 2007
Location: Valdosta, Georgia
Posts: 22
|
Re: Starting Problems
I took the air filter out and blew it off. It was practically clean. I changed the spark plug. I made sure that my battery was fully charged. And still, I press the ignition and the engine just turns over. Any thoughts? THanks for being patient with newbies.
Login or Register to Remove Ads |
|
10-20-2008, 06:10 AM | #6 |
Senior Member
Join Date: Aug 2006
Location: Tallahassee FL
Posts: 945
|
Re: Starting Problems
Do you have a spark? No spark, no start.
If the starter is spinning all of the interlock switches are working. |
|
10-21-2008, 01:30 AM | #7 |
Senior Member
Join Date: Jun 2008
Location: Bucks Co. PA
Posts: 361
|
Re: Starting Problems
Really check that the vacuum hose to the petcock is connected at both ends and is in good shape as Patrick_77 said. I had to cut a bit off both ends of mine to get a tight fit. No fuel will pass if not enough/no vacuum is present at petcock. The fuel line can also be bad-swollen shut inside. If you have spark and fuel it should start.
__________________
The real money in a gold rush is in supplying liqueur and women to the miners.... May the wind always be at your back and the sun overhead as you make your way down the ever winding, smoothly paved, traffic free road! |
|
10-21-2008, 08:11 PM | #8 | |
Senior Member
Join Date: May 2007
Location: Champaign, Illinois
Posts: 4,561
|
Re: Starting Problems
Quote:
__________________
Loud pipes risk rights! |
|
|
10-22-2008, 11:16 PM | #9 |
Senior Member
Join Date: Jun 2008
Location: Bucks Co. PA
Posts: 361
|
Re: Starting Problems
Easy, you are absolutely correct sir! :plus1:
__________________
The real money in a gold rush is in supplying liqueur and women to the miners.... May the wind always be at your back and the sun overhead as you make your way down the ever winding, smoothly paved, traffic free road! |
|
Thread Tools | |
Display Modes | |
|
|