Best way to clean the chain?

[bourbonjohnson]

I bought a bike with a VERY dirty chain. After looking at the chain for too long, I did some research and found that the chain does not have a master link.

I would like to know if there is a quick way to remove the chain without having to tear the bike apart. Do I need to buy a chain breaker or is there another option?

[Vegas Street Rider]

Everyone has their own way of doing things so you will get lots of answers. I put my rear tire up in the air and use WD40 and a chain brush moving the chain by turning the rear tire. I then wipe it clean after it has had time to soak in and then use DuPont Multi Lube Teflon spray instead of the traditional chain lube/oil. I have not seen any deterioration of the o-rings and the chain travels very quietly. I now have approximately 12,500 miles on the chain and it looks like new with no appreciable stretching.

[blaine]

Originally Posted by Vegas Street Rider

Everyone has their own way of doing things so you will get lots of answers. I put my rear tire up in the air and use WD40 and a chain brush moving the chain by turning the rear tire. I then wipe it clean after it has had time to soak in and then use DuPont Multi Lube Teflon spray instead of the traditional chain lube/oil. I have not seen any deterioration of the o-rings and the chain travels very quietly. I now have approximately 12,500 miles on the chain and it looks like new with no appreciable stretching.

I used to do the same......But lubed with PJ-1.

[5th_bike]

Manual says to use kerosene to clean it (I use it with a paint brush), and motor oil to lube (I use heavy gear oil).

Careful with the WD-40, it could deteriorate the o rings.

[blaine]

Originally Posted by 5th_bike

Manual says to use kerosene to clean it (I use it with a paint brush), and motor oil to lube (I use heavy gear oil).

Careful with the WD-40, it could deteriorate the o rings.

Kerosene is great (& cheaper)....W-D 40 will not harm the neoprene o-rings & Chan wax is much cleaner & wont attract dirt like gear oil............But to each their own.

[Water Warrior 2]

Kerosene and a brush here. Wipe clean and dry. Add your fav lube.

[wacio]

I would be carefull with wax as chain lube. From my long biking experience wax is ineffective. Yes - it keeps chain clean, but unless you lube every ride - it just doesn't stay on - causing quick wear and rust.

[blaine]

Originally Posted by wacio

I would be carefull with wax as chain lube. From my long biking experience wax is ineffective. Yes - it keeps chain clean, but unless you lube every ride - it just doesn't stay on - causing quick wear and rust.

I cleaned & lubed every 1000 Km & chain was still in great shape after 30000 km using PJ1.I found it perfect as it goes on liquid to penetrate & than thicken to stay in place.I also find it a great cable lube.

[wacio]

Originally Posted by blaine

I cleaned & lubed every 1000 Km & chain was still in great shape after 30000 km using PJ1.I found it perfect as it goes on liquid to penetrate & than thicken to stay in place.I also find it a great cable lube.

Thanks for response. I looked at the product you recommend. It is not described as wax. I actually see on manufacturers site:

"PJ1 New Improved Black Label Heavy Duty Chain Lube applies easily and penetrates into the pins and rollers to set up into a tacky, grease-like coating. PJ1 Black Label Heavy Duty Chain Lubes resilient coating reduces chain stretching and shock that normally is encountered during off-road racing and riding. Displaces and repels water. Will not harden and crack like wax"

My experience with wax lubricants was exactly as described bold above. It was flaking off easily and gone after few miles.

[blaine]

Originally Posted by wacio

Thanks for response. I looked at the product you recommend. It is not described as wax. I actually see on manufacturers site:

"PJ1 New Improved Black Label Heavy Duty Chain Lube applies easily and penetrates into the pins and rollers to set up into a tacky, grease-like coating. PJ1 Black Label Heavy Duty Chain Lubes resilient coating reduces chain stretching and shock that normally is encountered during off-road racing and riding. Displaces and repels water. Will not harden and crack like wax"

My experience with wax lubricants was exactly as described bold above. It was flaking off easily and gone after few miles.

Sorry....I stand corrected.....Wrong terminology on my part.