Turbocharged GZ250

therockbg · 05-09-2012, 05:34 PM

Hi guys. I am new around here. I read about the 16T sprokets and that the bike simply does not have the power to go good with it. I was wondering if anyone had actually tried to turbocharge one of these and succeed in the project .. I have a sprace small turbo that can probably fit nicely in between the frame and the engine. But i guess then i will need a new carboreutor that can supply more mixture ... and how about the stiffness of the engine itself - do you think it can survive a small boost of about 0.3-0.5 bars of pressure?
any feedback will be usefull before i decide to start this projec.

PS. I've done similar thing before to a car and the results were mainly in torque. the car was daihatsu charade 1.3 originaly started out with 92 hp on the dyno and the stock torque of 100 Nm. After the turbo with a boost of 0.33 bars we got 112 hp and astonishing clutch-breaking torque of 173 Nm ...

wacio · 01-27-2020, 09:18 PM

GZ250 would not have oil pressure to provide lubrication for turbo (needs minimum 40psi). GZ pump is providing 10psi.

05-09-2012, 05:34 PM	#1
therockbg Junior Member Join Date: May 2012 Location: Denmark Posts: 9	Turbocharged GZ250 Hi guys. I am new around here. I read about the 16T sprokets and that the bike simply does not have the power to go good with it. I was wondering if anyone had actually tried to turbocharge one of these and succeed in the project .. I have a sprace small turbo that can probably fit nicely in between the frame and the engine. But i guess then i will need a new carboreutor that can supply more mixture ... and how about the stiffness of the engine itself - do you think it can survive a small boost of about 0.3-0.5 bars of pressure? any feedback will be usefull before i decide to start this projec. PS. I've done similar thing before to a car and the results were mainly in torque. the car was daihatsu charade 1.3 originaly started out with 92 hp on the dyno and the stock torque of 100 Nm. After the turbo with a boost of 0.33 bars we got 112 hp and astonishing clutch-breaking torque of 173 Nm ... Login or Register to Remove Ads
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

01-27-2020, 09:18 PM	#2
wacio Senior Member Join Date: Apr 2016 Location: Illinois Posts: 174	GZ250 would not have oil pressure to provide lubrication for turbo (needs minimum 40psi). GZ pump is providing 10psi.
	0