1" handle bars

Palaka · 08-20-2010, 07:47 PM

I have done the seach for this and I know that the gz uses 7/8 handle bars I am just wandering what you would have to change out to get it to fit a set of 1" bars?
The reason for asking this is I went to pull the vibration caps off the handle bars and the inside of the bar is severly corroded and I need to replace them anyways. Also I have a nice set of grips I could put on them if it was a 1".
thanks for any info or help.

08-20-2010, 07:47 PM	#1
Palaka Member Join Date: Aug 2010 Location: Jacksonville, NC Posts: 31	1" handle bars I have done the seach for this and I know that the gz uses 7/8 handle bars I am just wandering what you would have to change out to get it to fit a set of 1" bars? The reason for asking this is I went to pull the vibration caps off the handle bars and the inside of the bar is severly corroded and I need to replace them anyways. Also I have a nice set of grips I could put on them if it was a 1". thanks for any info or help. Login or Register to Remove Ads
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode