|
Good morning Alan. Thanks for taking the time with me bro. To be clear on an earlier post of mine, The sidestand part....that is, the part that bolts to the actual stand down low is missing entirely along with all but an inch or two of the wires attached to it. The PO left a couple inches of the leads below the green harness/clip and twisted them together. My question is: is there a workaround for the missing part and its diode? You mentioned n your last post that the job was "half done". Could you perhaps explain what the other half would be that might prevent the ignition fuse from blowing?
Login or Register to Remove Ads
|