[b1pig]

i'm sure i'll have her bike taken apart again soon... lol..
i'll take a couple of pics and post them up on what i did.

its really easy. i used a larger bit than was necessary, but it worked fine.

steps for what i did:

leave fuel selector in "ON"
remove vaccum line from fuel sel
remove fuel line from carb... (rag for slight spillage)
remove the two 10mm bolts at rear of tank... and slide it off (towards rear)
remove the two screws from the throttle cable mounting tab on the (r) side of carb
loosen both clamps on the carb (airbox and intake)
slowly rotate the carb counter clockwise (as viewed from rear)


this gives access to both top and bottom of carb without having to remove the airbox or the air tube.